SilverSaver 1000 Quick Start Manual

SilverSaver 1000
ASSEMBLY INSTRUCTIONS
For guidance on product assembly, please refer to the User
Guide available at www.getsilversaver.com
SAFETY CONSIDERATIONS
• Keep out of reach of children, small parts are a
choking hazard.
• Do not mutilate the batteries.
• Dispose of batteries as per local regulations.
• Only charge the detector according to the instructions
in the manual.
• Do not dispose of the product or accessories in a fire.
REGULATORY INFORMATION
Federal Communications Commission (FCC)
Statements (as applicable)
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Part 15.105 NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Contact 1-877-767-6522
mail@getsilversaver.com
Regulatory Information
®
COMPLIANCE STATEMENTS FOR CANADA
This product meets the applicable Innovation, Science and
Economic Development Canada technical specifications.
INFORMATION RÉGLEMENTAIRE
Avis de conformité Canadien Le présent produit est conforme
aux spécifications techniques retenues par l'Innovation, Sciences
et Développement économique Canada (ISDE).
RSS-Gen Notice
This device complies with Industry Canada's license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) This device may not cause interference; and (2)
This device must accept any interference, including interference
that may cause undesired operation of the device.
RSS-Gen l'avis
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes: (1) l'appareil ne
doit pas produire de brouillage; (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Modification
Any changes or modifications not expressly approved by the
grantee of this device could void the user's authority to operate
the device.
Modification
Toute modification non approuvée explicitement par le
fournisseur de licence de l'appareil peut entraîner l'annulation
du droit de l'utilisateur à utiliser l'appareil.
1