Arpella LEDRD Installation Manual

ARPELLA

Please Read Before Installation

Please read these instructions carefully before starting installation and keep
in a safe place for future reference. Manufacturer recommends using a qualified
Electrician for all electrical wiring procedures. Please turn off all power to
site prior to installation.
Check the contents of the pack carefully before installation. Manufacturer is
not responsible for removal reinstallation costs where a defective product has
been installed. If any fault is found with materials or workmanship, it must be
reported immediately to the manufacture. Remedial action will be taken, based
on information received, on condition that.
1, Full details are supplied to the manufacture,
2 The product has not been modified or tampered with.
3, The manufacture is informed of any damage short ages prior to installation.
4, The product has not been installed, or attempts have been made to install.
We do not accept responsibility for any problems that may occur through incorrect
installation.

IMPORTANT SAFETY INSTRUCTION

When using an electrical furnishing, basic precautions should always be followed,
including the following:
Read all instructions before using (this furnishing).
DANGER – To reduce the risk of electric shock:
1. Always unplug this furnishing from the electrical outlet before cleaning or
servicing.
WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons:
2. Unplug from outlet before putting on or taking off parts.
3. Close supervision is necessary when this furnishing is used by, or near children,
invalids, or disabled persons.
4. Use this furnishing only for its intended use as described in these instructions.
Do not use attachments not recommended by the manufacturer.
5. Never operate this furnishing if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into water. Return
the furnishing to a service center for examination and repair.
6. Keep the cord away from heated surfaces.
7. Never operate the furnishing with the air openings blocked. Keep the air openings
free of lint, hair, and the like.
8. Never drop or insert any object into any opening.
9. Do not use outdoors.
10. Do not operate where aerosol (spray) products are being used or where oxygen