Operation - Glacier bay HD67762W-6001 Installation And Care Manual

Installation (continued)
11
Making the water supply
connections
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
NOTE: Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube tting.
This will prevent the supply tube from moving or twisting
when tightening the faucet connector. Do not overtighten.

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, loosen the
set screw (1) with Hex wrench (Hex: 1.5mm, U) provided,
then remove aerator (2) with aerator wrench (T) provided
to ush the water lines.
□
Ensure the faucet (A) handles are in the off
position and turn on the water supply to check
for leaks. If you discover any leaks, check your
connections to ensure they are installed properly.
□
Remove the aerator and housing (if applicable).
Turn on the hot and cold handles to allow the
water to run for at least one minute. This
ushes away any debris that could cause
damage to internal parts.
□
Turn off the water and reinstall the aerator and
housing (if applicable).
NOTE: When you reinstall the aerator (2) and tighten the
set screw (1) with Hex wrench (Hex: 1.5mm, U) provided,
make sure that the end face (3) of the set screw is aligned
with the face (4) of the spout.
1
3
4
3
2
T
9
Please contact 1-855-HD-GLACIER for further assistance.
2
3 4
U
A
1 U
HOMEDEPOT.COM