Advertisement
Quick Links
Advertisement
Related Manuals for FOFANA NINJA SLIDER LINE
Summary of Contents for FOFANA NINJA SLIDER LINE
- Page 1 User Manual and Setup Guide Thank You For your purchase!
- Page 2 If you have any issues please reach out to us: support@fofana.co We'll be glad to help you ASAP. Want to add a Ninja Course? Pick one up on our website: fofana.co/ninja or on Amazon.com: amazon.com/fofana...
- Page 3 Please use common sense and remember that you are responsible for your decisions as well as the outcome. Fofana and its associates are not responsible for anything that may go wrong with your slider line installation, trees, gear, pulleys, or related components. No warranty related to slider lines is expressed or implied by installation tips, construction guides, or by any representative of Fofana, including warranties of merchantability or fitness.
-
Page 4: Helpful Tips
• Have Rider begin at the low point in the line and pull them toward the Start. This eliminates the need for a raised platform. • Combine this Slider Line with one of our Fofana Ninja Warrior Obstacle Courses for the most deluxe backyard adventure available. - Page 5 Step 1. Determine the END height for Slider Line • Line should be set so that the fully extended seat hangs about 24 inches from the ground with the lightest rider sitting on the swing. • Add the values below to determine the End height: o 7’...
- Page 6 Step 3. Setting up the Slider Line • Determine which tree will be used as the Start, and the End. The anchor line and ratchet must be used at the End tree. This gives a small buffer so the pulley doesn’t reach the tree. The line must be setup so the rider comes to a stop before reaching the end of the line.
- Page 7 Locked Position Pull Line Tight Before Ratcheting Crank Ratchet Handle Fully Open Ratchet to Tighten Line Handle to Release Tension If you have any questions or problems, please contact us, we are glad to help! Visit Fofana.co/Ninja or email support@fofana.co...
- Page 8 Step 5. Mount Slider Pulley to Slider Slackline • Place Slider Pulley over the top of the slackline. • Make sure the longer side of the Slider Pulley hangs below the webbing line. See picture below. • Secure the Triangle Carabiner onto the Slider Pulley by threading it through the hole in each of the pulley side plates.