FOFANA NINJA User Slider Pulley User's Manual And Setup Instructions

WARNING! Safety Rules
•
For ages 8 and up.
•
Maximum user weight limit 250 lbs.
•
One person at a time.
•
Maximum distance from user feet to the ground is
18 inches.
•
Read all instructions before assembly.
•
Adult supervision required at all times.
•
For use only on 2" (50mm) wide slacklines.
•
Check for correct installation and for wear prior to
each use. If worn or damaged parts are found,
replace with Fofana replacement parts.
•
Adult assembly required, including site selection
and installation.
•
Area under slackline must be free of all hazards,
obstacles, obstructions, and other dangers nearby.
•
Load stress test must be performed before use.
•
All watchers should maintain a 10 foot distance.
•
Use healthy strong trees at least 1 foot in diameter.
•
Do not attach to unhealthy trees, injury may result.
•
Follow all instructions and heed all warnings in
slackline instruction manual and setup guide.
•
Do not use with an obstacle span greater than 20
feet or on slacklines set up with slope. This may
generate excessive speed which could cause injury.
Be safe, go slow.
•
Do not place fingers or hair inside of slider pulley or
serious injury may result.
•
Do not reach up to grab slackline webbing while
riding or as a spectator to slow down rider or
serious injury may result.
•
ALWAYS MAKE SURE YOUR RIDERS KNOW AND
FOLLOW THE RULES AND INSTRUCTIONS.
•
Poor installation, poor sight selection, inadequate
rider instruction, poor adult supervision or
improper use can cause severe injury or death.
The buyer, installer, and user of this product assume all
risk and accept all responsibility for any damage or
injury, including death, that may arise from its use.
Failure to follow these instructions could
result in serious injury!
If you have any questions or problems, please contact
us, we are glad to help!
Visit Fofana.co/Ninja or email support@fofana.co
User Manual User Manual
and Setup Guide and Setup Guide
Set Contents
•
1 Ninja Slider Pulley
•
1 Triangle Carabiner
Step 1. Properly set up Ninja Slackline
•
Follow the User Manual and Setup Guide for your
ninja slackline obstacle course.
•
Leave up to 20 feet of length at the beginning of
the course for the Slider Pulley obstacle.
•
Slider Pulley should be placed near the beginning
of the obstacle course so the user can slide down
the webbing toward the middle when the line sags
due to the user weight.
•
Line should be set so that the shortest user's feet
hang 12 inches from the ground while hanging
from the obstacles at the middle of the webbing.
Step 2. Mount Slider Pulley to Ninja Slackline
•
Place Slider Pulley over the top of the slackline.
•
Make sure the longer side of the Slider Pulley
hangs below the webbing line. See picture below.
•
Secure the Triangle Carabiner onto the Slider
Pulley by threading it through the hole in each of
the pulley side plates. Triangle Carabiner must pass
through both side plate holes or it may fall off.
•
Attach a hanging obstacle to the Triangle Carabiner
and lock the securing nut closed. See picture.
•
Make sure all connections are tight and perform
the mandatory load stress test by using either a
250 lbs person or weight suspended from the line.
Step 3. It's Ninja Time!
•
Have fun, but make sure users do not get too much
speed. Be safe, go slow.