Location Requirements - Vissani VDH50P Use And Care Manual

Pre-Installation (continued)
Customer's Responsibility
□ To contact a qualified electrician.
□ To assure that the electrical installation is adequate and conforms to the national electrical code. ANSI/NFPA 70-last edition, and all
local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
www.nfpa.org
Wiring Requirement
Power supply
115V 103.5V min. 126.5V max.

LOCATION REQUIREMENTS

WARNING: To reduce the risk of injury to persons, malfunction, or damage to the
product or property when using this appliance, follow basic safety precautions, including
the following:
□ Do not locate outdoors. This dehumidifier is intended for indoor, residential use only. This
dehumidifier is not recommended for commercial use.
□ Allow at least 12 in. to 18 in, (30.5 cm to 45.7 cm) of space on the rear and sides of the
dehumidifier for models with back louver and above the dehumidifier for models with top
louvers.
□ You will need a surface strong enough to support the dehumidifier when its bucket is full of
water.
□ You will need a surface level enough to keep the water from spilling when the bucket is full
of water.
□ Do not block the louvers of the unit.
□ Never operate this dehumidifier in an area that is likely to accumulate standing water. If this
condition develops, for your safety disconnect the power supply before stepping into the
water.
Time-delay fuse (or circuit breaker)
15A
5
12 in. to 18 in.
(30.5 cm to 45.7 cm)
Please contact 1-877-527-0313 for further assistance.
HOMEDEPOT.COM