geos SD582BT Quick Setup Manual

User Quick Setup Manual
1. Open the package and check the appearance
and accessories
2. Please press the button to turn the scanner on
3. Connecting and transmitting schemes
Attention please: The default connection mode of the scanner
is 2.4G, which can be configured into Bluetooth mode as needed.
After booting, it will try to connect according to the connection
method before shut down. For example, before the scanner turns off,
the scanner and the mobile phone Bluetooth pair successfully. After
rebooting, the scanner will automatically connect to the mobile
phone while the mobile phone has not ignored the scanner and its
Bluetooth on.
Scanner function setting step:
Enter Settings Reading function barcode
3.1 Bluetooth mode
Turn on the Bluetooth of terminal devices and use the scanner
scans"EnterSettings"-"BluetoothHID Mode"-"Searching"-"Exit
Settings" in sequence. Find and choose the "Barcode Scanner HID"
on the terminal device to connect. If successfully, the blue colored
indicator will be on. (Note: For the meaning of indicator refer to part
7).
①Enter Settings
②Bluetooth HID Mode
③Searching
3.2 2.4G mode
After plugging Dongle into the computer and the computer
identifying Dongle successfully, pls. scan "Enter Settings"-"2.4G
Mode"-"Connect Dongle"-"Exit Settings" in sequence to pair.
After connect successfully, the blue colored lights will be on. (Note:
For the meaning of indicator refer to part 7).
①Enter settings
Exit Settings
③Connect Dongle
4. Active Factory Defaults
Scanning the "Active Factory Defaults" barcode below will
return the scanner to its factory configuration. This barcode does not
change the connection and transmission method.
5. Function configuration
④Exit Settings
②2.4G Mode
④Exit Settings
Active Factory Defaults
5.1 Configure carriage return (CR)
Add CR
Add CR/LF
6. Power down method
The scanner will automatically shut down after it connects
successfully but not in use longer than 10 minutes. When you do not
use the scanner device, you can scan the following barcodes in
sequence to shut down the scanning device directly.
①Enter Settings
7、Country languages
line feed (LF)
,
Add LF
Clear CR/LF
②Power Down