Table of Contents
Advertisement
OPERATION
1. Make sure the amplifier or receiver power is OFF
and set the volume to minimum.
2. Set the volume on the volume control to maximum
(fully clockwise).
3. Turn ON the amplifier or receiver and select a
source, such as the tuner or CD player.
4. Slowly turn up the amplifier or receiver volume
and set it to a comfortable – not maximum –
listening level. Don't overdrive or "clip" your
amplifier. If the sound becomes muddy or
distorted, you have reached the limit of your
amplifier's volume capability. Reduce the volume
at once to avoid damaging your speakers.
5. JobSite Muting Volume Controls come from
the factory pre-programmed in the automatic
mute mode. When the Amplifier turns on, you
should see the Mute Button on the volume
6
control, light up Red. No sound will be present in
the Mute mode.
6. To turn ON the speakers in a room, tap the Mute
Button, on the Volume Control, once. The Mute
Button will change from Red to Green. Adjust the
volume of the speakers to the desired listening
level using the volume control knob. If all the
speaker pairs in your system are equipped with
JobSite volume controls, you can set the amplifier
or receiver volume at one position and use the
JobSite controls exclusively.
7. To turn OFF the speakers in a room, tap the Mute
button, on the Volume Control, once. The Mute
button will change from Green to Red and the
speakers will turn off.
Advertisement
Table of Contents
