JVC GR-AX880US Service Manual page 22

2.4.2 Disassembly of MONITOR ASSEMBLY <3.5 TYPE>
NOTE :
Be careful not to soil or scratch the monitor screen through the
disassembly/assembly work.
(1) While removing the three screws 1 to 3 in numerical order
and disengaging the two hooks (L7a and L7b) in alphabet-
ical order, remove the MONITOR COVER ASSEMBLY.
NOTE 7a :
After removing the MONITOR COVER ASSEMBLY, be
careful not to damage the FPC and the connector be-
cause the MONI. HINGE ASSEMBLY moves very easily.
(2) Unlock the connector 7a and then remove the FPC while
lifting the MONI. HINGE ASSEMBLY upwards to remove it
together with the FPC.
NOTE 7b :
When removing the FPC, unlock the connector first and
then lift the MONI. HINGE ASSEMBLY upwards.
Accordingly, the FPC is removed together with the
MONI.HINGE ASSEMBLY.
(3) Unsolder the two soldered parts (SD7).
NOTE 7c :
When removing the MONITOR BOARD ASSEMBLY and
the BACK LIGHT together, it is not necessary to unsol-
der the two soldered parts (SD7).
NOTE 7d :
It depends on the inch size of the monitor assembly
whether the backlight is supplied as an assembly or as
separated parts.
In replacing the backlight assembly, see the Parts List.
NOTE 7e :
Attatchment of the WIRE.
(4) Unlock the connector 7b, and disconnect the FPC from the
connector 7b.
(5) Disconnect the SENSOR BOARD ASSEMBLY from MON-
ITOR CASE ASSEMBLY.
(6) Remove the screw (4), and remove the MONITOR BOARD
ASSEMBLY while lifting the side of MONITOR BOARD AS-
SEMBLY which has been attached with screw (4) upwards.
(7) Remove the BACK LIGHT.
(8) Remove the LCD FRAME&LCD MODULE while disengag-
ing L7e and L7f at the both sides of MONITOR CASE AS-
SEMBLY.
(9) Remove the S.CASE.
MONITOR COVER
ASSEMBLY
2
(S7b)
3
(S7b)
<NOTE 7b>
CN7a
a
L7e
b
SENSOR BOARD
ASSEMBLY
<NOTE 7a>
MONI. HINGE
a
ASSEMBLY
<NOTE 7e>
WIRE
SD7
Fig.2-4-2
L7b
L7a
1
d
(S7a)
4
CN7b
(S7a)
c
f
<NOTE 7c>
SD7
BACK LIGHT
ASSEMBLY
<NOTE 7c,d>
LCD FRAME
c
LCD MODULE
S. CASE
L7g
b
L7f
MONITOR CASE
ASSEMBLY
d
WIRE
(No.86721)1-13