Advertisement
PREPARING FOR INSTALLATION:
If you are installing the V-12 into an existing wall, take time to consider any
possible obstructions which may be hidden inside the wall, such as wood or
metal studs, electrical, telephone or other types of wiring, plumbing, AC or
heating conduit. Count the number of pairs of 4-ohm speakers and the number
of pairs of 8-ohm speakers you are connecting. Count pairs of 6-ohm speakers
as 4-ohm pairs. Determine the correct switch position from the impedance
charts in the owner's manual.
INSTALLATION:
1. Identify the Speaker wire and Amplifier wire. Label the wires for future
reference.
2. Strip 1/4" of insulation from the end of each wire. Tightly twist the end of
each wire until no frayed ends remain.
3. Locate the snap and lock connectors and remove them if they are plugged in.
4. Use a small flathead screwdriver or your thumb to raise the locking tabs,
exposing the holes on the connector.
5. Insert each wire into the appropriate hole and snap down the locking tabs.
6. Insert the smooth side of the connector plug into the smooth side of the
V-12 socket.
7 . Install the V-12 into the device ring.
8. Set the Impedance Magnification Switch as determined by the
impedance charts.
9. Set the switches, on all of the controls, to the same position
(1x, 2x, 4x, or 8x).
10. Fasten the cover plate.
V-12 INSTALLATION DIAGRAM
12 STEP WALL MOUNT VOLUME CONTROL
Input From
V-12
Amplifier
V-12 Side
View
Output to
Speakers
Stereo Receiver
Speakers
JOBSITE SYSTEMS
12331 SW 130 STREET
MIAMI, FL 33186
P 866.4JB.SITE (866.452.7483)
F 305.238.0185
WWW.JOBSITESYSTEMS.COM
©2004 Niles Audio Corporation. JobSite,
Pure Custom and Niles are registered
trademarks of Niles Audio Corporation
and the JobSite Logo is a trademark of
Niles Audio Corporation. JSV12PDF
Specifications subject to change without notice.
V-12
Advertisement
