Cossiga DTGOR User Manual

ga
COSSI
This is a guide only. If you are unsure of any aspects of the installation or operation, please contact us or
visit our website
The appliance is not to be used by persons (inclusing children) with reduced physical, sensory or mental
capabilities, or lack of experince or knowledge, unless they have supervision or instruction
Children should be supervised so they do not play with the appliance
The applicance is intended to be used for comercial applications, but not for the continuous mass
production of food.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
simmilarly qualified persons in order to avoid hazard.
Do not store explosive substances such as aerosol cans with a flammable propellant in
this appliance.
No hot water on glass.
Appliance shall not be cleaned with a water jet or a steam cleaner
Always disconnect this appliance before cleaning and servicing
Servicing should only be carried out by an approved service agent, registered electrician or refrigeration engineer
Do not use a multi-box or overload your power supply
Risk of fire / flammable materials
WARNING: Keep clear of obstruction all ventilation openings in the appliance enclosure or in the structure for
building-in.
WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
WARNING: Do not damage the refrigerant circuit.
WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they
are of the type recommended by the manufacturer.
DEFROST
( RF OR RA UNITS)
UNIT DEFROST WHEN FLASHING
COMPRESSON IS OFF
LIGHT
SWITCH

SHELVES

Adjustable:
- Height
- Flat or Angled
To Adjust:
- Remove Racks
- LIFT up from back of
shelf arms at either end
DTGOR USER GUIDE
Thank you for purchasing a Cossiga food display cabinet
www.cossiga.com

CONTROLLER INSTRUCTIONS

COMPRESSOR ON
(RF OR RA UNITS)
HEATING ELEMENTS ON
POWER
SWITCH

LED LIGHTING

.

SAFETY

AIRFLOW FAN ON
1
PRESS AND HOLD
FOR 3 SECONDS
PROTECTED
FRAME
LED are easily replaced:
- Slide old LED out and slide new one in
Can be disconnected from rear pillar by unplugging socket
TO ADJUST TEMPERATURE
2 3
SET POINT WILL PUSH ARROWS TO
FLASH ADJUST SET POINT
All controllers are
preset for certified
food safety -
avoid unnecessary
adjustments
4 4
4
PRESS SET TO
CONFIRM