× Bookmark added
Download Print This Page

Jobsite S-4VC Installation And User Manual

Speaker selectors with volume controls.
Hide thumbs


For Connecting Four/Six
Pairs of Speakers to an
Amplifier or Receiver,
with Precise Volume
Adjustment in any Zone


   Also See for Jobsite S-4VC

   Related Manuals for Jobsite S-4VC

   Summary of Contents for Jobsite S-4VC

  • Page 1

    INSTALLATION & USER GUIDE For Connecting Four/Six Pairs of Speakers to an Amplifier or Receiver, with Precise Volume Adjustment in any Zone S-4VC/S-6VC SPEAKER SELECTORS WITH VOLUME CONTROLS...

  • Page 2: Table Of Contents

    S-4VC / S-6VC SPEAKER SELECTORS WITH VOLUME CONTROLS TABLE OF CONTENTS Features...1 Product Overview...2 Package Contents ...3 Preparing for Installation...3 Installation...3 Operation...5 Specifications ...6 Warranty...7...

  • Page 3: Features

    FEATURES S-4VC: Safely connect up to four speaker pairs to a single amplifier or receiver S-6VC: Safely connect up to six speaker pairs to a single amplifier or receiver 12-step make before break volume control High power handling capability Built-in protection circuit...

  • Page 4: Product Overview

    PRODUCT OVERVIEW Recessed areas for custom room labels. Attractive low- profile design. Simple push-button operation. Impedamce Magnification 12 position volume control provides greater attenuation than conventional 10 position designs. Connect up to two pairs of speakers. Removable Connectors. Selection. S -4V C SPEAKER SELECTO R/VOL UME CONTR Figure 1...

  • Page 5: Package Contents, Preparing For Installation, Installation

    INSTALLATION 1. Select an appropriate location for the S-4VC/ S-6VC. 2. Run all the necessary wiring to the S-4VC/S-6VC. Label the wires for future reference. 3. Strip 1/4" of insulation from the end of each wire. Tightly twist the end of each wire until no frayed ends remain.

  • Page 6

    10. Locate the pre-printed Room Labels. Affix the appropriate label to the recessed area over each on/off selector button. See installation diagram. Figure 2 Connecting the wires S-4VC INSTALLATION DIAGRAM Connecting the wires S-4VC Stereo Receiver Speaker...

  • Page 7: Operation

    1. Count the number of pairs of speakers you are connecting to the system. 2. Set the Speaker Pairs switch on the rear panel of the S-4VC/S-6VC to match the number of pairs of speakers (1, 2, 3/4, 5/6). See Figure 3. Figure 3 OPERATION 1.

  • Page 8: Specifications

    Individual runs of 2-conductor speaker wire to each speaker Removable connectors accommodate 10-22 gauge wire (16-gauge recommended) Mounting: Tabletop component Dimensions: S-4VC: 17" wide x 2" high x 9-1/8" deep S-6VC: 17" wide x 2” high x 9-1/8" deep Warranty: 10 year limited...

  • Page 9: Warranty

    This Warranty is subject to the following additional conditions and limitations. The Warranty is void and inapplicable if JOBSITE deems that the product has been used or handled other than in accordance with the instructions provided by the manufacturer,...

  • Page 10

    SHIPPING INSTRUCTIONS FROM JOBSITE. If the above conditions are met, the purchaser’s sole remedy shall be to return the product to JOBSITE, in which case JOBSITE will repair or replace, at its sole option, the defective product without charge for parts or labor.

  • Page 11

    For the name of the nearest authorized JOBSITE wholesale distributor, contact: JobSite Systems 12331 S.W. 130 Street, Miami, Florida 33186 WWW.JOBSITESYSTEMS.COM...

  • Page 12

    WWW.JOBSITESYSTEMS.COM © 2004 JobSite Systems. All rights reserved. JobSite, Pure Custom and Niles are registered trademarks of Niles Audio Corporation and the JobSite Logo is a trademark of Niles Audio Corporation. All other trademarks are the property of their respective owners. Some JobSite products (or components thereof) are manufactured under one or more U.S.

This manual also for:


Comments to this Manuals

Symbols: 0
Latest comments: