Advertisement
PREPARING FOR INSTALLATION:
The IR-E1HO is typically used as a "flooding" emitter to control a stack of
audio/video components. For this type of application, place the IR-E1HO with its
LED's pointed straight up and at least an inch in front of the equipment you
wish to control. For tall stacks of components use multiple IR-E1HO emitters.
Make sure the mounting surface is cleaned and degreased before installation.
INSTALLATION:
1. Test the operation of the IR-E1HO in the planned mounting location. If all of
the components operate correctly via the IR repeater system, proceed.
2. Make sure the mounting surface is clean.
3. Remove the protective coating from the self-adhesive tape and attach the
IR-E1HO to the mounting surface.
4. Route the connecting two-conductor wire to the IR Connecting Block and
plug it into an Emitter output.
5. Coil any excess wire and tie it in place.
6. On IR Connecting Blocks with selectable Emitter outputs make certain the
HI-LOW SWITCH is placed in the HI position.
IR-E1HO INSTALLATION DIAGRAM
JobSite
IR-E1HO
Emitter
POWER
+12V DC
IR CONNECTING BLOCK
HIGH OUTPUT IR EMITTER
IR-E1HO
Receiver
1
2
3
4
5
3-30V
12VDC/
AC/DC
OUTPUT
EMITTER OUTPUTS
STATUS
IN
12V DC Power
HI
HI
Supply
IR-CB2
LOW
LOW
(Not Supplied)
IR RECEIVER INPUTS
1
2
plugged into
the Switched
IR-CB-2
Outlet
IR-SMR
12V DC Power Supply
Plugged into an Unswitched
AC Outlet Powers the System
DSS
CD
Stereo
JOBSITE SYSTEMS
12331 SW 130 STREET
MIAMI, FL 33186
P 866.4JB.SITE (866.452.7483)
F 305.238.0185
WWW.JOBSITESYSTEMS.COM
©2004 Niles Audio Corporation. JobSite,
Pure Custom and Niles are registered
trademarks of Niles Audio Corporation
and the JobSite Logo is a trademark of
Niles Audio Corporation. JSIRE1HOPDF
Specifications subject to change without notice.
IR-E1HO
Advertisement
