VisionTek CANDYBOARD RF06 User Manual page 4

Charging the battery
This device utilizes a built- in lithium-ion battery, please use
only approved data lines and chargers. Note: Fully charge
the unit before operating for the first time. This device can
be used when charging, but will extend the charging time.
When the battery is low, the low-voltage light will flash
to warn the user. The unit will automatically turn off if the
battery has been depleted.
Note: Fully charge the unit before operating for the first
time. This device can be used when charging, but will
extend the charging time.
How to operate
1 Press the Set1/Set2 of "remote" for 3 seconds, the
remote's light will flash once time then stay on for long-time
2 Aim the remote's infrared LED at your original remote
control's infrared LED in parallel alignment (PS: the relative
distance not more than 7 cm), then press any button on
remote, the remote's light will flash two times then long¬time
on, it is in learning status.
3 Press any button on original remote control, remotes light
will flash three times then another long light when success-
fully learned.
4 Repeat the step 2-4, until finish learning all keys.
5 Press the set key or 10 seconds without any operation, the
device will retire from the learning state.
6 7