Advertisement
Function Setup
Customizing the function settings (Continued)
DVD recorder operation
AV record quality
DVD-RW
DVD-RW
HDD
DVD-RAM
(VR)
DVD-VIDEO
VCD
CD
You can select from 4 combined picture and sound
quality recording settings prior to actual recording.
Actual selection applied becomes the default setting for
the normal recording or programmed recording.
e.g.
AV record quality
HDD rec
DVD rec
Manual mode set.
Rate
Audio quality
Total recording time: approx.
(with 4.7 GB unused)
Sound and picture quality for the three recording settings
of XP, SP and LP cannot be altered. You can freely
change the settings by using "Manual mode set".
Set in advance frequently used recording settings for
DVD or HDD.
AV record quality
1) Press the
/
buttons to select the media to
record.
2) Press the
/
buttons to select the recording
settings.
Manual mode set.
1) Press the
/
buttons to select the desired
item, "Rate" or "Audio quality".
2) Press the
/
buttons to change the setting.
You can adjust "Rate" by 0.2 Mbps from 1.0 to
9.2. (You cannot set the rate from 1.0 to 1.4 and
1.4 to 2.0.)
• If you set the rate of the "Rate" setting to 9.2,
XP may be displayed in spite of the Audio
quality setting.
3) Press the ENTER button.
Note
• Depending on the sound quality settings, the upper limit for
the picture quality setting differs.
124
RD-XS24SG_Ope_E_p115-128
DVD-R
DVD-R
(Video)
(VR)
(Video)
XP
9.2
D/M1
SP
4.6
D/M1
9.2
D/M1
61min.
124
Picture record mode
DVD-RW
DVD-RW
HDD
DVD-RAM
(VR)
(Video)
DVD-VIDEO
VCD
CD
Adjusts problems with the brightness of video signals of
TV broadcasts or other external input.
Press the
/
buttons to select the source, and the
buttons to select the mode.
(Only use this setting when you cannot adjust the
brightness satisfactorily with the "Custom picture setting"
in the "Picture/Audio settings" (
recorder.)
Important:
• This setting changes the video signal to record and the
recorded signal is not returned to the original state even
when this setting is changed after recording. When
duplicating from VHS tape, if you can check the video
recording state beforehand, we recommend first playing
back for a while and checking the overall brightness
tendency, then setting an appropriate mode.
Standard:
The brightness of signals received with this recorder
and external input signals is adjusted automatically.
Use this mode normally.
Mode 1:
This setting is used to record the signals darker when
the screen is too bright.
Mode 2, 3, 4:
As the number rises, the signals are recorded brighter.
Use these modes to adjust the brightness.
11/28/05, 17:47
DVD-R
DVD-R
(VR)
(Video)
/
Page 120) of this
Advertisement
