Http Port; Https Port; Weight - Teletronics International EZMesh User Manual

User Guide - EZMesh Full Duplex Mesh Network Access Point
EXAMPLE: (IP address and Gateway should under same domain.)

Http Port

The default Http Port for MeshAP is 80. Http Port could be set to any port number based
on the network administrator's requirement.
To reassign a number Http Port enter the desire port number to Http Port field. And Click
Save Setting and Apply

Https Port

The default Https Port for MeshAP is 443. Http Port could be set to any port number based
on the network administrator's requirement.
To reassign a number Http Port enter the desire port number to Https Port field. And Click
Save Setting and Apply

Weight

Weight number (1 – 10) help identify the level of connection desire for the nodes (Stations)
to connect to particular Mesh Manager unit on the Mesh. Setting a Mesh Manager's Weight
to "10" may force all nodes on the mesh network to associate with this Mesh Manager than
other Mesh Manager on the mesh. Whereas Setting Mesh Manager to "1" may force this
Mesh Manager low chance for Nodes to associate to compare with other high Weight
number Mesh Manager on the mesh.
Note: Total Bandwidth score is based on Hop Count, Signal Quality, and Mesh Manager
Weight. This guideline affects the routing decision of each node on the mesh to decide
which Mesh Manager to associate
To set Mesh Manager weight, Enter number (1-10) in the "Weight of this Mesh Network"
field and Click Save Setting and Apply
TELETRONICS INTERNATIONAL, INC.
Mesh IP Address: 192.168.0.120, and Gateway IP: 192.168.0.1
- 20 -