Table of Contents
Advertisement
CONNECTION DETAILS
COUPLING COLD AND HOT PIPES TO COLLECTOR – SCREWED FITTING
Refer to
installation diagram
and
Detail E
on page 24.
1.
Seat a washer (6) into the collector connection.
2.
Place the connector (10) into the collector connection and screw in the
union by hand until it seats firmly against the washer (6). Tighten an
additional half turn, applying medium pressure, with a spanner. Do not
over tighten.
3.
Place the compression nut (11) and olive (12) over the end of the solar
cold pipe. Position the cold pipe into the connector (10), seat the olive (12)
and tighten the compression nut (11).
4.
Repeat this procedure with the connector (10) to couple the solar hot pipe
to the solar collector (17).
CLAMPING COLLECTOR TO COLLECTOR RAIL
Refer to
installation diagram
and
Detail G
on page 25.
1.
Position the collector clamp (13) over the hole in the collector rail (1) with
the top lip of the clamp over the collector trim.
2.
Insert the hex screw through the hole in the collector clamp and collector
rail (1), place the washer and nut on the screw and screw the nut until it
seats firmly against the lip of the collector rail, applying medium pressure
with a spanner to tighten.
on page 28 for position and
on page 28 for position and
22
Detail D
on page 24
Detail F
on page 25
Advertisement
Table of Contents
