Advertisement
Riverside
emai info@riverside-furniture.com.
M5/16" x 3/4" Allen
5/16" Spring
Head Bolt
Washer
8 pcs.
M5/16" x 5/8" Allen
Head Bolt
6 pcs.
Middle Leg
Wire Hoops
1 pc.
K
L
C
B
E
C
B
D
Note:
1. To prevent possible scratches or damage, assemble the TV Console upside down on a soft surface such as a blanket or carpet.
2. Assemble two Front Legs (G) to the bottom of the TV Console using the 3/4" Allen Head Bolts (A), Spring washers (B), and Flat
washers (C).
3. Assemble two Back Legs (H) and one Middle Leg (I) to the bottom of the TV Console using the 5/8" Allen head bolts (E), Spring
washers (B), and Flat washers (C)
4. Tighten all Bolts using the supplied Allen wrench (D).
5. Carefully turn the TV Console upright.
6. Install the Wire Hoops (J) into the holes on the Pull-Out Media Shelves.
7. If required, the TV Console can be adjusted using the levelers screwed into the bottom of the legs to compensate for uneven
floors.
8. If the TV Console is being used without the Deck, the Anti-Tipping Restraints should be connected to the back of the Console.
Firmly attach the Restraint to a wall stud using the Wood Screws (L). Move the Console to near the wall and install the
Anti-Tipping Restraint Strap.
FURNITURE
5/16" Flat Washer
14pcs.
14 pcs.
TV Console
Front Leg
1 pc.
Anti-tipping
Restraint
12 pcs.
Stone Forge
TV Console
5mm Allen
Wrench
1 pc.
Back Leg
2 pcs.
2 pcs.
Wood screw
2 pcs.
4 pcs.
Page 4 of 4
Made in China
31040 TV Console
Be sure to check all
packing material
carefully for small
parts, which may have
come loose inside the
carton during shipment.
J
C
I
D
Advertisement
