Advertisement
3.
AIR SUPPLY
The recommended hook-up is shown in fig. 4.
3.1.
Ensure the air valve is in the "Off" position before connecting to the
air supply.
3.2.
You will require an air pressure of 0.5 bar.
3.3.
! WARNING! Ensure the air supply is clean and does not exceed
pressures specified in these Instructions. Too high an air
pressure and/or unclean air will shorten the drainer life due to
excessive wear, and may be dangerous, causing damage and/or
personal injury.
3.4.
Drain the air tank daily. Water in the air line may damage the drainer.
3.5.
Clean the air inlet filter screen weekly.
3.6.
Line pressure should be increased to compensate for unusually
long air hoses (over 8 metres). The minimum hose diameter should
be 10mm I.D. and fittings must have the same inside dimensions.
3.7.
Keep hose away from heat, oil and sharp edges. Check hoses for wear, and make certain that all connections are secure.
4.
OPERATION
WARNING! Ensure that you read, understand and apply the safety instructions in Section 1.
!
4.1.1.
To raise or lower the drain pan, slacken off the handwheel (Fig. 5.1) while supporting the weight of the drain pan, move drain pan to the correct
height and then tighten the hand wheel.
Note! Oil should be removed when hot (70-80°C). Keep hands, face and body protected using suitable personal protective equipment (PPE).
4.1.2.
Drain the oil into the drain pan ensuring that the drain pan tap is open (Fig. 5.2) and the ball valve tap at the base of the resevoir is closed (Fig. 3F).
4.1.3.
When draining is complete lower oil pan before moving drainer.
WARNING! Ensure the oil level never rises above the maximum level on the indicator located on the side of the resevoir.
!
4.2.
Emptying
4.2.1.
Ensure that drain pan valve (Fig. 6.2) is closed and clamp (Fig. 6.1) is tight.
4.2.2.
Attach the end of the drain hose to a suitable waste oil container (Fig. 6).
4.2.3.
Open ball valve (Fig. 6. 5).
4.2.4.
Connect air supply at a pressure of 0.5bar to coupling (Fig. 6.4) and open valve 3 (Fig. 6.3).
4.2.5.
After the fluids have been transferred from the resevoir close valve 5 (Fig. 6.5).
4.2.6.
Disconnect from air supply and vent any pressure remaining in the resevoir by opening drainpan valve (Fig 6.2) and/or air valve (Fig 6.3.).
NOTE! This unit is equipped with a safety valve that has been factory calibrated at 0.5bar.
2
Fig. 5
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
1
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
Fig. 4
CLOSE
Fig. 6
01284 757500
01284 703534
1
2
3
4
5
www.sealey.co.uk
Web
sales@sealey.co.uk
email
AK458DX.V3 - 1 - 150206
Advertisement
