Related Manuals for MILLU MI-017
Summary of Contents for MILLU MI-017
- Page 1 Ceramic Stainless tea mill M I - 01 7 Ceramic blade without losing natural flavor Granularity adjusting style you can choose your own granularity...
- Page 2 Names of parts Grip Handle Cover Shaft Bdoy Stopper (movable ) A djustment ring 2 pieces ( ) Ceramic blade upper blade lower blade Fixed pin Granularity screw To turn right ( c lose) - fine grain To turn left ( l oose) -coarse grain coarse fine You can choose the thickness/ fineness as you like. Container All the parts are expected to be set appropriately. If setting is not right, it may cause the poor ...
- Page 3 Please read before use ・ The mill is set to fine grinding when shipped. ・ Make adjustments to the powder roughness after trying the initial setting. ・ Turning the handle with no tea leaves added can damage the ceramic blade. How to use Adjust the roughness Close the cap and Open the cap and granularity. put the tea inside grinding by turning the container. the handle. (See roughness grain (Clockwise) size adjustment method) Roughness grain size adjustment method (How to turn adjustment screw) Handle Roughness grain size adjustment screw Set the handle, then by controlling it, ...
- Page 4 To take body and ceramicblade apart Remove the fixing pin and Take the granularity adjustment screw out. the lower blade while ( c ounter clockwise ) pressing the fixing pin. tapping tapping screw tip screw tip Tap the tip of the screw Take out the adjustment part lightly on a cloth screw ( 2 pieces ) and remove the upper blade. 1. Ensure that there are no objects around when disassembling the mill. 2. When removing the ceramic blade, do not drop it or hit it against hard objects, as this can cause cracking or chipping. 3. After ceramic blade washed, use it after dried w ell. 4. Set each part firmly. Inappropriate setting ...
- Page 5 The way of assembling of body and ceramic blade Dimples at Dimples at three places three places Overhang part Overhang part at three places at three places Set the adjustment ring Try to adjust 3 hollows in the body to the to the body. ( 2 pieces ) projection of upper blades. Side with lines Side with lines Slit part of the fixed pin Slit part of the fixed pin Overhang part of shaft Overhang part of shaft...
- Page 6 Caution ・ At first time, clean by using sponge with cleanser for plates. Use it after drying well. ・ For using at some fixed place, put the mill at tabilized place. If used at unstable condition or wet place, it may cause some troubles. In case of grinding in the air, try to grip the mill firmly. ・ This mill is designed only for green tea (dried tea leave). Do not use other tea leave. Except dried tea leave, other food materials may cause the troubles, therefore do not use them absolutely. ・ Tencha leaves with stem and veins removed can be ground even more finely. ・ Be careful not to drop the mill or hit, otherwise mill may break. In case of breaking, do not use anymore. ・ Be careful not to grind some foreign materials like small stones. In case of the blade will be broken, do not use the mill. ・ If some strange rubbing noise is heard with idle grinding of handle, and If used continuously, it it may cause some troubles. ※Adjusting screw should be turned to left. （ rough grinding ） ・ If adjusting screw will be turned too much to the right, turning operation will not be smooth by rubbing of ceramic blades. This may cause the troubles. If rubbing noise will be heard, adjusting screw should be turned to the left a little bit. ※If you turned adjusting screw too much, ceramic blade may be broken. Be careful for this operation.
Need help?
Do you have a question about the MI-017 and is the answer not in the manual?
Questions and answers