Features & Specifications Features: Adjustable speed. Suited for inductive loads. 4 channels with LED indicator. Ideal for disco effects. Noise suppressed according to EN55015. Specifications: AC Power : 110 to 240 VAC. Auto frequency detection : 50/60Hz. Max load per channel 2A : 200W (110 - 125VAC) 400W (220 - 240VAC) Adjustable speed : 0,2 to 3Hz.
Assembly hints 1. Assembly (Skipping this can lead to troubles ! ) Ok, so we have your attention. These hints will help you to make this project successful. Read them carefully. 1.1 Make sure you have the right tools: A good quality soldering iron (25-40W) with a small tip. •...
Page 5
Assembly hints 1.3 Soldering Hints : 1- Mount the component against the PCB surface and carefully solder the leads 2- Make sure the solder joints are cone-shaped and shiny 3- Trim excess leads as close as possible to the solder joint REMOVE THEM FROM THE TAPE ONE AT A TIME ! AXIAL COMPONENTS ARE TAPED IN THE CORRECT MOUNTING SEQUENCE !
Page 6
Construction 1. Zener diode. Watch the R8 : 270 (2 - 7 - 1 - B) 6. Capacitors R9 : 270 (2 - 7 - 1 - B) polarity ! C3 : 100nF (104) 4. Metal film resistors C4 : 100nF (104) C6 : 100pF (101) ZD...
Page 8
Construction 17. Capacitor 19. Hook - up & use 200W at 110-125VAC 400W at 220-240VAC MAX ! For each channel. : 680nF / 600V 18. IC. Watch the position of the notch! IC1 : VK8032 AC PLUG Programmed PIC12C508A Inspect the complete Solder an AC cable to the SK1 pins (AC Power).