Table of Contents
Advertisement
90
Troubleshooting Power/Remote Issues
Please check the list below when you experience the following symptoms during use of
the product. It may not be a failure.
I cannot turn on the Projector.
•
Please make sure your projector power plug is correctly connected to the outlet.
•
If you are using a multi-outlet, check if it is working properly. To check whether a
power strip is working properly, plug the projector's power plug directly to a wall
outlet and observe its operation.
•
Try to power on using the button on your projector set.
•
If you are using a standby power cut-off switch, turn off the standby power cut-
off and turn the power on again.
The power is on, but the screen does not turn on for some time.
•
It is not a sign of defect because the screen may turn on later to prevent
possible noise from the screen when the power is turned on.
The pointer of Magic Lighting Remote does not appear on the screen.
•
Hold the remote control towards the projector and press the
Settings) buttons at the same time more than 5 seconds until instructions
appear. The previously registered remote control is deregistered and then
registered again.
•
Replace the batteries when you are prompted to do so on your projector screen.
(Use alkaline batteries.)
(Q. Settings) →
•
If
is set to [On], the pointer of the Magic Lighting Remote does not appear.
Set [Audio Guidance] to [Off]. (Some models may not be supported.)
→ [General] → [Accessibility] → [Audio Guidance]
(Q.
and
Advertisement
Chapters
Table of Contents
Troubleshooting
