Jabra JX20 PURA Getting Started

Charge and turn on your headset what the lights mean
When the device is fully
What you see
charged all 5 steps of
the LED are lit.
Solid light
Quick flash every 5 seconds for
1 minute
LED flashing for 1 second, then
1½ second pause then repeats
LED flashing twice and then
turning off
LED flashes once then solid white
LED flashes once
LED flashes twice
On/off switch
(rotate earpiece
LED flashes three times
90 degrees).
LED flashes four times
LED soild white
Pairing the headset with your Phone
1a: First time pairing: 1b: Later pairing:
What this means about your
Turn headset on - automatically Turn headset on - Press and hold
headset
goes into pairing mode. the answer / end button until
the LED on the back shines
The headset is in pairing
continuously.
mode
Connected and not on active
call (reappears if you have
asked for battery status)
Incoming call
Pairing succeeded
Pairing failed
0-25% charged
25-50% charged 2. Activate Bluetooth on you phone.
3. Press 'Yes' on the phone and confirm with PIN code 0000 (4 zeros).
50-75% charged
4. Typical view in mobile phone.
75%-100% charged
Fig. 1
JX20 PURA
JX20 PURA
Fully charged
using your headset
Control volume
Answer a call
Press volume up
End call
Press volume down
JX20 PURA
wearing style attaChing earhook
With earhook Without earhook
Place eargel over earpiece
Eargel