Table of Contents
Advertisement
Warning and indicator lamps in the instrument cluster
Display messages
Â
Key not detected
Key not detected
(red display message)
Â
Remove
Remove starting
starting but‐
but‐
ton, then
ton,
then insert
insert key
key
Warning and indicator lamps in the instrument cluster
General notes
Some systems carry out a self-diagnosis when the ignition is switched on. Several warning and
indicator lamps can thereby temporarily light up or flash. This behaviour is non-critical. These
warning and indicator lamps only indicate a malfunction if they light up or flash after the engine is
started or during a journey.
Possible causes/consequences and M M Solutions
The key is not in the vehicle.
A warning tone also sounds.
If the engine is switched off, you can no longer lock the vehicle cen-
trally or start the engine.
Pull over and stop the vehicle safely as soon as possible, paying
X
attention to road and traffic conditions.
Safeguard the vehicle against rolling away (
X
Locate the key.
X
Press a on the steering wheel to confirm the display message.
X
Because there is interference from a strong source of radio waves, the
key is not detected whilst the engine is running.
A warning tone also sounds.
Pull over and stop the vehicle safely as soon as possible, paying
X
attention to road and traffic conditions.
Safeguard the vehicle against rolling away (
X
Insert the key into the ignition lock and bring into key mode.
X
The key is continually undetected.
The key detection function has a temporary malfunction or is faulty. A
warning tone also sounds.
Insert the key into the ignition lock and turn it to the desired posi-
X
tion.
Consult a qualified specialist workshop.
X
page 154).
Y
page 154).
Y
Z
259
Advertisement
Table of Contents
