Table of Contents
Advertisement
3. Open the door. Remove all the items
from the drum .
5. Remove the polystyrene protection from
the bottom. Put the appliance back into an
upright position.
7. Remove the three transit bolts and pull
out the plastic spacers.
We recommend that you
keep the packaging and the
transit bolts for any transport
of the appliance.
3.2 Information for installation
Positioning and levelling
1
2
4. Put the front polystyrene packaging
element on the floor under the appliance.
Carefully put down the appliance onto its
rear side.
6. Remove the power supply cable and the
drain hose from the hose holders.
It is possible to see water flowing from the
drain hose. This is because the washing
machine has been tested at the factory.
8. Put the plastic caps, that you find in the
user manual bag, in the holes.
Adjust the appliance correctly to prevent
vibration, noise and movement of the
appliance when it operates.
1. Install the appliance on a flat hard
floor. The appliance must be levelled and
stable. Make sure that the appliance
does not touch the wall or other units and
there is air circulation below the
appliance.
ENGLISH
7
Advertisement
Table of Contents
