Auto Power On/Off; Manual Power On/Off - Midland STREET GUARDIAN DUAL User Manual

Charge and power on/off instructions
Only the car charger included in the box can be used to power on the device, otherwise it could be
damaged or could not work properly.
Connect one end of the car adapter to the USB connector of the camcorder mount.
Plug the other end of the car charger to the cigarette lighter socket of your vehicle. Once the vehicle
engine is started, the camcorder automatically powers on.
Attention: in some vehicles the cigarette lighter has no outage after the vehicle turns off, this means that
the automatic turning on/off is not possible. Therefore the camera must be manually switched on/off.
Please make sure to charge the device at least two hours before using it: if the battery is completely dischar-
ged, the camera will return to default settings.

Auto power on/off

When used as driving recorder, it is required to turn ON the "Loop Recording".
In this way, if the camera is connected to the car charger when the vehicle engine is turned on, it will
start recording video; when the vehicle engine is turned off, the data will be saved, and the device will
automatically shutdown.
Attention: in some vehicles the 12V plug does not switch off the power when the engine is turned off, the-
refore the automatic turning on and off cannot be done. You have to do it manually.

Manual power on/off

Press the button to turn on the device: the blue led of the
To switch off the DVR, keep pressed the
Attention: in case of very low battery, the camera will emit an acoustic sound and then switch off.
Recharge
To recharge the car camcorder connect it to the 12V car charger or to the PC with its USB cable.
The camera however, must be always powered while in use : the built-in battery is used only to
correctly save the file before turning off the device. In standby conditions the battery life is a few
minutes, so it must be always used while powered through the cable.
Battery indicators as below:
Full
button: the blue led of the
Half
19
button will start blinking.
button will switch off.
Low Empty (unit turns off)