Kenwood DPX795BH Instruction Manual page 37

Installation/Connection
Part list for installation
(A) Mounting sleeve ( ×1 )
(C) Trim plate (only for Toyota car) ( ×1 )
(E) Round head screw ( ×6 )
( )
(G) Wiring harness ( ×1 )
(B) Trim plate ( ×1 )
(D) Extraction key ( ×2 )
(F) Flat head screw ( ×6 )
( )
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Connect the wires properly.
See "Wiring connection" on page 33.
3
Install the unit to your car.
See the following "Installing the unit (without mounting sleeve)".
4
Connect the terminal of the car battery.
5 Press B SRC to turn on the power.
6
Reset the unit. (Page 4)
Installing the unit (in-dash mounting)
Do the required wiring.
(Page 33)
Dashboard of your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
31
ENGLISH