Download Print this page

influencer INVLTPK14 Quick Start Manual

14 inch ring light studio kit

Download this manual

Inﬂuencer™

PO Box 5658 Brendale QLD

Australia 4500

Customer Support 1800 812 261

1711/ 5

14 INCH

RING LIGHT

STUDIO KIT

INVLTPK14

Welcome to the #inﬂuencer

14 Inch Ring Light Studio Kit.

Let's get you up to speed so

you can start creating great

content!

FEATURES

• Tripod 73cm-210cm

• LED ring light

• Single and double phone mount

• Microphone arm

• Bluetooth

selfie remote

*Ring light is 14 inch high as measured

from mounting point to top of the ring.

Page 1 14 INCH RING LIGHT STUDIO KIT INVLTPK14 Welcome to the #inﬂuencer 14 Inch Ring Light Studio Kit. Let’s get you up to speed so you can start creating great content! FEATURES • Tripod 73cm-210cm • LED ring light • Single and double phone mount •...
Page 2 INCLUDED 1 x 14 Inch ring light 1 x Camera mount 1 x Dual phone bracket 1 x Microphone mount SECTION 2: RING LIGHT 1. Remove the assembled ring light from packaging. 2. Pull down the base mount of ring light so that one of the adjustment screws is lower than the other (Fig.
Page 3 SECTION 3: PHONE MOUNT SECTION 4: MICROPHONE MOUNT There are multiple phone mounting options in this kit. 1. Unscrew the end cap of the microphone arm (Fig. 1A & 1B). 2. Loosen the adjustment bolt on microphone arm joint connector (Fig. 2). A.
Page 4 SECTION 5: CAMERA MOUNT 1. Attach the metal camera mount to the camera base first. 2. Attach the camera base to the ring light mount by placing in the slots then tighten the base adjustment ring. Note: Don't over extend the microphone arm otherwise you risk tipping the tripod over.