Air Hose Connection; Material Hose Connection - Mamba AirCombi Operating Manual

MAMBA
AirCombi Spray Gun

5.4 Air hose connection

Attention: It is suggested to install an air filter on the gun air line to ensure a dry, clean air supply to the
gun. Dirt and moisture can ruin the appearance of your finished worked piece. Install an air pressure reg-
ulator on the gun air line to control air pressure to the gun. Install an air shutoff valve on the gun air line
and on the pump air line, to shut off air to the gun. Use a 3/16" (5mm) or even larger air hose to minimize
excessive pressure drop in the hose.
1. Connect the air hose the air inlet placed on the gun.
2. Connect the other end of the air hose to the air pressure regulator placed on the pump

5.5 Material hose connection

Note: Before connecting the fluid line, blow it out with air and flush it with solvent. Use solvent which is
compatible with the fluid to be sprayed. If better control of fluid pressure is needed, install a fluid regulator
on the fluid line to better control fluid pressure to the gun.
3. Connect the material hose to material inlet placed on the gun.
4. Connect the other end of the material hose the material outlet placed on the pump.
Note: Only use hoses supplied or approved by the manufacturer
WARNING: Inspect hoses before each use. Never use a damaged hose. High pressure in hoses with wear,
leaks or splits may cause the hose to rupture and cause serious personal injury. Never try to stop or deflect
leaks with any part of your body.
OPERATING MANUAL Page 9