System Leds - IME enginko LoRaWAN MCF-LW13IO Operating Manual

2022/06/24 09:08
Move the NFC antenna of the mobile (the exact position varies depending on the model of the
smartphone) to the sensor antenna, in the area shown in the figure:
To use the NFC interface, the device must be powered through terminals L LINE and N LINE. The
power status is visible on the red/green led.
Always validate your settings by reading the NFC data after the sensor has restarted.
Configuration can be done only via NFC. No USB port available.

2.5 System leds

LoRaWAN® not configured
Joining
Sending
Receiving
Steady state
Data error
Connection error
e n g i n k o . s u p p o r t . c e n t e r - https://www.enginko.com/support/
5/21
Slow flashing
Quick flashing
Quick flashing
Quick flashing
Fixed
Flashing 2 seconds
Flashing 1 second
www.ime.de
manual_mcf-lw13io