Rompa BUMBLE BEE MASSAGER 19189 Quick Start Manual

Page 1 of 2 Copyright ROMPA® Ltd

BUMBLE BEE MASSAGER 19189

CONTENTS
1 x Bumble Bee Massager
Please note: This product requires, but does not include, 2 AA batteries

BEFORE USE

Install Batteries: Gently lift off the top part of the Bumble Bee. Insert two batteries observing
the polarity indicated. Do not mix old and new batteries. Do not use rechargeable batteries.
Use only AA batteries. Replace the lid.

USE

The Bumble Bee Massager can be used in two ways:
Switched off, the Bumble Bee Massager provides a gentle 'rolling' massage, using gentle
circular or up and down motions.
Switched on, the massage is more invigorating. To switch the Bumble Bee Massager on, press
the button on his nose.
Suggested use: on back, neck, legs or arms.
Do not apply too much pressure onto the Massager. Experiment till the desired amount of
pressure is achieved. Use over clothing if desired, remembering that increasing the number of
layers will decrease the intensity of the massage.
Use for five minutes initially, gradually increasing the time as desired, up to fifteen minutes.
This is a suggestion only – use will depend on individual preferences and requirements.
Discontinue use immediately if discomfort is experienced.
Switch off after use. Forgetting to do so may cause the Bumble Bee to vibrate himself off a
table etc!
For use in dry environments only. Do not immerse in water.
Take care not to drop the massager – the batteries are likely to become dislodged.
The use of this product is in no way intended to replace medical treatment.
If in any doubt about the suitability of this product consult your doctor before use.
CARE & MAINTENANCE
Store in a cool, dry place.
Replace batteries as soon as operation becomes erratic. If replacing batteries, switch off first.

SAFETY

Always supervise the use of this product. This is not a toy. For three years and above.

SPECIFICATION

Weight: 0.25kg
Approximate Size: 10x10x13cm
BUMBLE BEE MASSAGER 19189, KH 11.09