Kucht KR Series Installation Manual page 8

Confiden�al
To avoid the risk of electric shock:
Connect the plug to a grounded 3 pin socket.
Do not remove the ground terminal of the plug.
Do not use adapters.
Do not use extension cables.
ATTENTION:
Failure to follow these instruc�ons may result in death, fire or electric shock. Connec�ng the grounding conductor of
the equipment to an improper place may lead to electric shock. Please have the grounding checked by a qualified
electrician or service technician if you have any doubt about the proper grounding of the product.
Installa�on, repair and other procedures performed by unqualified persons may cause danger. Before installing the
appliance, make sure that the voltage, load and circuit current parameters on the data plate are in compliance with
the power mains in your house.
The appliance is provided with a NEMA 5 15 P plug and a 3 pin power cable which is in the UL list and ready to be
connected to a 120 V, 60 Hz power supply. Fuse is 15 A. The appliance must be connected to a 3 pin socket. The plug
must be installed only by a licensed electrician.
If the electrical wiring or the electric power supply of the house needs altera�on, the necessary procedures must be
performed by a qualified electrician.
ATTENTION:
Do not install your refrigerator:
In open areas
In environments where water is dripping
In environments where temperature is lower than 55° F (0°C)
Furniture:
Make sure that the furniture where you will install the appliance has been safely mounted in your kitchen.
Your furniture must be connected to the floor and the wall properly and with suitable connec�ons.
For the best installa�on, clearances between the furniture and the product must be in compliance
with the values specified in the installa�on instruc�ons.
Side walls must be free of clearances and their surfaces must be flat.
Minimum thickness of the side walls must be 5/8" (16 mm).
Minimum thickness of the doors to be a�ached to the product must be ¾" (19 mm) .
8
WWW.KUCHT.COM