ALDI 4x4 TOUGH 22-72020 Instruction Manual page 9

Wiring Installation
8. Connect the suitable piggyback connector "A" to the vehicle's headlight.
9. Connect the piggyback connector "E" to the piggyback connector "A" referring to the diagram on page
10 as a guide.
10. Connect the vehicle's high beam wiring loom plug "B" to the connector "A3" of the piggyback adaptor "A"
11. Connect the Splitter cable plugs "I" to each of the mounted LED Driving Lights & Light Bar "G". When
connecting the Splitter cable plug, carefully route the insulated sleeved wire cables to make sure that are clear
of moving parts, sharp edges and heat sources.
12. Secure all excess wire to the vehicle using cable ties (not included). Again ensure that all cables and
connections are clear of moving parts, sharp edges and heat sources.
13. Run the wiring harness to the battery and attach the red to the positive terminal and the black to the
negative terminal. Make sure the cables are securely tightened.
14. Replace the inline fuse "D" which was previously removed prior to installation. Refer previous instruction 4.
IMPORTANT. It is highly recommended that you engage a licenced automotive
electrician to install the driving lights if you are not familiar with automotive
electrical wiring.
IMPORTANT The LED Driving Lights and LED Light Bar MUST ONLY illuminate when
the main high beam head lamps are switched to the "Lamps ON" position in your
vehicle. Check that this is the case prior to driving your vehicle.
WARNING. Ensure that the installation and wiring including all cables and
components DO NOT come into contact with moving parts, sharp edges or hot
engine surfaces.
9
(Continued)