Sunsky G2 Quick Start Manual

Gps speed meter

Table of Contents

Download this manual

GPS Speed meter: G2

Warning:

This product working voltage is 5V, and it is forbidden to use a voltage higher than 5V for

power supply.

1. Satellite icon: After the satellite is found, it stops flashing and goes out before it can be

used normally. N-North S-South W-West E-East

2. Atmosphere light: Right press the wave button to turn off, again to turn on

3.Multi-function display: vehicle speed, time, vehicle speed + time, number of satellites,

travel distance, travel time (Short press the wave button vertically to change the function)

4. Atmosphere light: Right press the wave button to turn off, again to turn on

5. Multi-function display unit: TRIP mileage,TIM clock, MPH miles ,KM/H kilometers

Table of Contents

Do you have a question about the G2 and is the answer not in the manual?

Page 1 GPS Speed meter: G2 Warning: This product working voltage is 5V, and it is forbidden to use a voltage higher than 5V for power supply. Display functions: 1. Satellite icon: After the satellite is found, it stops flashing and goes out before it can be used normally.
Page 2 Wave button function 1.Short press in: Switch to vehicle speed , Time, Vehicle speed + time, Number of satellites ,Travel distance ,Travel time 2.Long press in: Enter the setting, after adjusting, press vertically for 2 seconds to save and exit 3.Push left: Switch to standard mode or concise mode 4.Long push left: Push left for 2 seconds to turn off the buzzer alarm, do it again to turn on 5.Push right: Switch to concise mode or standard mode (move option after entering setting)
Page 3 Over speed 0-250 When the vehicle speed alarm reach to 150, HUD will give the alarm Fatigue 1.0-8.0 HUD will give fatigue driving alarm driving alarm each 4 hours Brightness 0-11 0=automatic sensitivity adjustment adjustment 1-11=manual adjustment 1=darkest, 11=brightest 1→11 is increasing Speed unit 0=KM/H (kilometers) 1=MPH (miles)
Page 4 Troubleshooting 1.The screen without any display, and no power Check whether the USB cable is damaged, replace the USB cable for testing, and prohibit the use of voltage higher than 5V for power supply 2.Without Car Speed After HUD power-on, the satellite icon flashes will start to look for the satellite. Please driving the car to the open road.