Technical Specifications; Service; Warranty; Copyright, Trademarks - Pro-Ject Audio Systems Box Design Power Box RS2 Phono Instructions For Use

Technical specifications Pro-Ject Power Box RS2 Phono
Input Power supply:
Output voltage/current/ripple
Output voltage/current/ripple
Dimension (W x D x H):
Weight:

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the unit
be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons, release the
manufacturer from any liability over and above the lawful rights of the customer.

Copyright, trademarks

Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright © 2022. All rights reserved.

Declaration of Conformity

We, Canor spol. s r.o.
Družstevná 13925/39
08006 Prešov
Slovakia
(manufacturer)
and
Pro-Ject Audio Systems a division of Audio Tuning GmbH
Margaretenstrasse 98
1050 Vienna,
Austria
(distributor)
declare under our responsibility that the product is in conformity with the provisions of Directives:
2014/35/EU including amendments
2014/30/EU including amendments
STN EN 62368-1:2015 - Safety
STN EN 55035:2018 - Electromagnetic compatibility of multimedia equipment - Immunity requirements
STN EN 55032:2015 - Electromagnetic compatibility of multimedia equipment – Emission requirements
115V/230V AC
1 x 15V ±0,5% / 2A / max. 35mV pp
1 x ±18V ± 0,5% / 2A / max. 50mV pp
206 x 209 x 71
2930 g
© Pro-Ject Audio Systems · Pro-Ject Power Box RS2 Phono · Revision 2022.01.03
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
3