Advertisement
Quick Links
Before using your Marodyne LiV device, please familiarise yourself with
the 'Instructions for Use' guide enclosed with your device
Place your device on a dry, hard
and level floor (e.g. a tile/stone
floor or a thin carpet)
Ensure the device is positioned
where you intend to use it.
When the device is powered on,
it must not be moved
Connect the power cord into the
switching adaptor
Plug the power cord into the
back of the device
Connect the AC power plug into
a mains power socket. A green
light will display on the power
brick to indicate the device is
receiving power
Switch the device on using the
rocker switch located at the
back of the device. A blue light
will signal it is successfully
switched on
V4 - 14/07/2022
When switched on, the device
will undergo a series of light
cycles as it calibrates
Once the calibration is
complete, the word 'Go' will
display on the device and a
beep indicates it's ready for
use. A single green light at the
centre of the feet indicates the
device is in standby mode, and
you can begin your session
Do not wear shoes while using
the device. It is recommended
you wear socks
Step onto the device from the
back and place your feet
approximately shoulder width
apart. It is recommended you
stand on the device with your
big toes in line with the bottom
of the Marodyne LiV logo
Advertisement
Related Manuals for MyBones Marodyne LiV
Summary of Contents for MyBones Marodyne LiV
- Page 1 Before using your Marodyne LiV device, please familiarise yourself with the ‘Instructions for Use’ guide enclosed with your device When switched on, the device Place your device on a dry, hard will undergo a series of light and level floor (e.g. a tile/stone...
- Page 2 Do not move the device whilst it is in (This takes a few seconds). You standby mode. Ensure your have 5 minutes to step back Marodyne LiV device is turned off at onto the device before the timer the rocker switch first** resets and the device re-enters...
- Page 3 You should not wear shoes, only socks while using the device A single green light in the centre of the display will indicate you are positioned correctly. You should feel the vibrations all the way up to your If you remain completely still for too long, the sensors in the Marodyne LiV device may interpret that you have stepped off and the device will go into standby mode.
- Page 4 The yellow lights indicate you are distributing your weight unevenly. The lights show you how to adjust your stance. See the diagram below for an explanation of what each light indicates: User is leaning or standing too far to the front User is leaning User is leaning or standing too far...
Need help?
Do you have a question about the Marodyne LiV and is the answer not in the manual?
Questions and answers