Advertisement
QuickStart Guide
Marodyne LiV
Before using your Marodyne LiV device, please read and familiarise yourself with the 'Instructions for Use'
1. Set Up
•
Place your device on a dry, hard and level floor (e.g. a tile/stone floor or a thin carpet)
•
Ensure the device is positioned where you intend to use it. Once the device is powered on, it
must not be moved
2. Power Assembly
•
Connect the power cord into the switching adaptor
•
Plug the power cord into the back of the device
•
Connect the AC power plug into a mains power socket. A green light will display on the
switching adaptor to indicate the device is receiving power
•
Switch the device on using the rocker switch located at the back of the device. A blue light
will signal it is successfully switched on
3. Getting Started
•
When first switched on, the device will undergo a series of light cycles as it calibrates
•
Once the calibration is complete, the word 'Go' will display on the device and a beep
indicates it's ready for use. A single green light at the centre of the feet indicates the device
is in standby mode, and you can begin your session
SETsquared Bristol, Approach Road, Temple Meads, Bristol, BS1 6QH
V1 – 13/01/2022
guide packaged with your device
info@mybones.health | 0117 253 0400
Advertisement
Table of Contents
Related Manuals for MyBones Marodyne LiV
Summary of Contents for MyBones Marodyne LiV
- Page 1 QuickStart Guide Marodyne LiV Before using your Marodyne LiV device, please read and familiarise yourself with the ‘Instructions for Use’ guide packaged with your device 1. Set Up • Place your device on a dry, hard and level floor (e.g. a tile/stone floor or a thin carpet) •...
- Page 2 • Step onto the device and place your feet about a shoulder width apart. It is recommended to stand on the device so that your big toes are in line with the bottom of the Marodyne LiV logo Correct foot placement •...
- Page 3 If you remain completely still for too long, the sensors inside the Marodyne LiV device may interpret that you have stepped off and will pause the session to conserve energy. Alternatively, you may need to stand slightly further forward on the device to ensure your weight is correctly positioned over the sensors.
Need help?
Do you have a question about the Marodyne LiV and is the answer not in the manual?
Questions and answers