Do you have a question about the HW1216 and is the answer not in the manual?
Questions and answers
Michele
April 10, 2025
My hw1216 washing machine won’t spin. Does the light for the no spin button need to be lit or not for it to spin. This is a new machine
1 comments:
Mr. Anderson
April 10, 2025
No, the No Spin button light should be off for the Haden HW1216 washing machine to spin. If the No Spin function is activated (light is on), the machine will not perform a spin cycle.
Transit Hole Plugs Positioning the Water Drainage Hose Electrical Connection Product Overview The Unit Control Panel Preparation Preparing Laundry Adding Detergent and Softener Operation Before First Use Standard Washing Other Functions Programmes Washing Programmes Tables Maintenance Cleaning Troubleshooting Technical Specifications Guarantee www.haden.com...
Make sure that the door of your Washing Machine is not restricted and • can be opened fully. • Ensure that the voltage and frequency of the power source are identical to those of the washing machine. www.haden.com...
Page 4
Keep pets away from your machine. • • Pets and children may climb into the machine. Check the machine before each use!! The glass door can become very hot during use. Keep children and pets • far away from the machine during use. www.haden.com...
Page 5
Never open the detergent drawer while the machine is running. In the event of a breakdown, unplug the machine from the mains supply • and turn the water supply off. Do not attempt to carry out any repairs. Always contact an authorised service agent. www.haden.com...
Page 6
The machine door must not be used as a handle during transportation. 4. The machine must be carried by at least 2 people. Your machine is for domestic use only. Using it for commercial purposes will cause your warranty to become void www.haden.com...
The materials used to package the machine may be dangerous to children. Please ensure that these materials cannot be accessed by children, and dispose of them according to local regulations. Please do not throw the packaging materials away with household waste www.haden.com...
- Away from heat sources such as coal or gas fires. - Leave a 20mm gap at least between the side and back of the unit. Make sure that the power cord is not trapped beneath the washing machine. Do not install the washing machine on a carpeted floor. www.haden.com...
Connect the inlet pipe as indicated. 1) Connect the straight end of the hose to the cold water outlet at the installation location. The outlet must be fitted with a ¾” threaded connection. Ensure it is tightened adequately so that it does not leak. www.haden.com...
Your Washing Machine must only be connected to your water supply using the supplied new fill hose. Old hoses must not be reused. Transit Hole Plugs Hole plugs can be used to plug up the holes at the back of the machine after the transit bolts have been removed. www.haden.com...
• electrician to avoid hazard. The machine must be earthed properly. If a short circuit occurs, earthing can reduce the risk of electrical shock. DO NOT DISASSEMBLE THIS APPLIANCE. TOUCHING SOME OF THE INTERNAL COMPONENTS CAN BE EXTREMELY HAZARDOUS. www.haden.com...
Product Overview Top Cover Water supply hose Control Panel Power supply cord Detergent dispenser Drum Door Service filter Drain hose Accessories Cold Water Transits hole Instruction supply hose covers x 4 Manual www.haden.com...
Laundry will undergo extra rinse once after selected. 4. No Spin The spin function is disabled for this cycle. 5. Start/Pause Press to start or pause the cycle. 6. OFF Turn to this position to turn off the washing machine. www.haden.com...
Reverse textiles such as pants, knitwear, t-shirts and sweat shirts. Wash socks, handkerchiefs and other small items in a washing net. Check the label Take all items out of the Knot long strips, close zips and pockets buttons www.haden.com...
Page 16
(such as short socks, handkerchiefs and ties) should be put into a string bag for washing. Heavy single items such as towels, jeans and bulky jackets may cause an imbalance in the motion of the drum. www.haden.com...
Apply detergent and softener according to the washing amount, soiling level, the water hardness in your area and the manufacturers instructions of these products. For slightly dirty clothes, put a small amount of detergent into • compartment II of the drawer. www.haden.com...
Page 18
Wash out unused softener with a splash of water or a damp cloth after • the programme has finished. • You can use liquid detergents in all programmes. Dilute viscous fabric softener and fabric conditioner with water to prevent blockage of the overflow. Maximum level is 40ml. www.haden.com...
Once the washing machine beeps the door will remain closed for 1 • minute before unlocking. Open the washing machine door and remove your washing. • • Remove any foreign objects to avoid risk of rusting. • Leave the door and detergent drawer open so that residual water can evaporate. www.haden.com...
Press and hold both the Extra rinse and No spin buttons for 3 seconds to activate the Child Lock during a washing cycle. To release Child Lock during the cycle, hold the same buttons down once more for around 3 seconds www.haden.com...
90 °C high temperature sterilization. When this procedure is performed, the clothes or other washing cannot be added. Drum Clean When proper amount of chlorine bleaching agent is put in, the barrel cleaning effect will be better. Cold water wash Cold Wash www.haden.com...
Page 25
∙ The values given for the programmes other that the ECO 40- 60 programme are indicative only. ∙ The New EU energy efficiency class is D. Energy test program: ECO 40-60. Speed: the highest; other as default Half load for 7kg: 3.5kg Quarter load for 7kg: 2kg www.haden.com...
Page 26
Noise and remaining moisture content are influenced by the spinning speed: the higher the spinning speed in the spinning phase , the higher the noise and lower the remaining moisture content. www.haden.com...
Cleaning the Door seal and Glass Wipe the glass and seal after each wash to remove lint and stains. If lint builds up it can cause leaks. Remove any coins, buttons and other objects from the seal after each wash www.haden.com...
Page 28
Open the filter by turning counter clockwise. Water may drain out this is normal. 3. Remove any lint and debris before carefully replacing the filter. 4. Turn the filter clockwise to screw back into place. Close the service panel. www.haden.com...
Check that transport bolts have been removed Check that appliance has been Abnormal noise installed on a solid, level floor. High levels of Check inside the drum for metal vibration articles such as hairpins Check that legs of washing machine are level www.haden.com...
Page 30
Water overflow Restart the washer Overtime water draining Check if the drain hose is blocked Restart after the door is closed Check if Door is not closed properly the clothes is stuck Others Call up service line if issue continues www.haden.com...
Technical Specification Model HW1216 HW1217 Rated Voltage 220 -240V ~ Rated Frequency 50Hz Rated Power 2050 W Spin Speed 1200 Dimensions (W*D*H mm) 595 x 440 x 850 Washing Weight 55kg Washing Capacity Rated Current 10 A Operating Water Pressure 0.05 MPa ~ 1 MPa...
Page 32
• To avoid increasing landfill. WEEE product should be disposed of by handing it over at a designated collection point. For more information about where you can drop off your waste product for recycling please contact your local authority www.haden.com...
Guarantee Your Haden product is covered by Guarantee for 24 months from the date of the original purchase. If the product fails within this period due to faulty materials or workmanship, it will be repaired, replaced or refunded at our discretion Please ensure you register your product and keep your receipt (proof of purchase) and serial number in a safe place.
Need help?
Do you have a question about the HW1216 and is the answer not in the manual?
Questions and answers
My hw1216 washing machine won’t spin. Does the light for the no spin button need to be lit or not for it to spin. This is a new machine
No, the No Spin button light should be off for the Haden HW1216 washing machine to spin. If the No Spin function is activated (light is on), the machine will not perform a spin cycle.
This answer is automatically generated