Table of Contents
Advertisement
1)
Problem
Incorrect programme selection.
The filter is clogged.
iron dry .
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi-
The loading
tion.
door does not
Laundry is trapped between the
close
door and the seal.
It is not possible
After a cycle starts it is not possible
to change the
to change the programme or op-
programme or
tion.
option.
It is not possible
The option you tried to select is
to select an op-
not available for the selected pro-
tion. An acoustic
gramme.
signal is emit-
ted.
There is no
Defective drum lamp.
drum light
Unexpected du-
The drying duration is calculated
ration time ap-
according to load size and damp-
pears on the dis-
ness.
play.
The water container is full.
A programme is
inactive.
Possible cause
Dryness option was set to
4)
Remedy
Select a suitable programme.
3)
Clean the filter.
Change
Dryness option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi-
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Contact the service centre to re-
place the drum lamp.
This is automated - the appliance
is working correctly.
Drain the water container, push
the
Start/Pause button.
ENGLISH
21
2)
5)
3)
3)
Advertisement
Table of Contents
