Table of Contents
Advertisement
26 Additional Contents 2
26.1 Self-Diagnostic Display Function
(Corrections)
With reference to Original Service Manual on page 52~54 (Section 13.5.3)(SA-PM29P/PC-S).
With reference to Original Service Manual on page 53~55 (Section 13.5.3)(SA-PM29E/EB/EG-S)
With reference to Original Service Manual on page 50~52 (Section 12.5.3)(SA-PM29GN/GD-S)
26.1.1 Doctor Mode set up (Corrections)
1.
Turn on power for unit.
2.
Select CD Mode. Ensure no disc is inserted in the unit.
3.
Press & hold [STOP] button for at least 2 seconds, follow by [4] & [7] on remote control. It enters into doctor mode.
4.
Power down to exit by pressing [POWER] button on main unit.
26.1.2 CR16 Mechanism Ageing Mode (Additional)
To enter into ageing mode :
1.
Enter self-diagnostic mode. (Doctor Mode)
2.
Press [3] button on remote control. It enters into ageing mode. (See below for ageing process)
Ageing process
1.
Tray 1 open.
2.
It waits for one second (Note : Do not put any disc into the tray)
3.
Tray 1 close.
4.
TOC READ (Reading incomplete)
5.
Tray 2 open & repeat process 1 to 4. (Process repeat until Tray 5)
6.
Tray check.
7.
Whole process complete (Counter on FL increase by 1)
Note : To exit ageing mode, press [POWER] button. The unit will power down. Do not unplug the power cord until FL display
shows " GOODBYE ". This is to avoid tray jam problem.
Display Example : [ 0 0 0 0 0 T 3 O P ] ...TRAY OPEN
[ 0 0 0 0 0 T 3 C L ] ...TRAY CLOSE
[ 0 0 0 0 0 T 3 R E ] ...TOC READING
[ 0 0 0 0 0 T 3 C H ] ...TRAY CHANGING
FLE0401D / A / J / M / S / E
Advertisement
Table of Contents
