Table of Contents
Advertisement
Connections
Speaker Components
(L) (R)
FRONT
STAND
(L) (R)
STANDBASE
REAR
Installing the Speakers on the Tallboy Stand
1.
Turn the Stand Base upside-down and connect
it to the Stand.
2.
Insert small screws (4*20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
!
CAUTION : When you use a torque screw-
driver, be careful not to put excessive force.
Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm
3.
Connect the upper Speaker to the assembled Stand.
4.
Insert another large screw (5*15, For connecting
Speaker & Stand) clockwise into the hole on the
rear of the speaker using a screwdriver.
5.
This is the appearance after the speaker is
installed. Follow this steps to install other
speaker.
1
English
Connecting the Speakers
SCREW (5x15): 4EA
SCREW (4x20): 16EA
CENTRE
SUBWOOFER
SPEAKERCABLE
FRONT/REAR SPEAKER
1
Stand
Base
Stand
3
Speaker
Stand
5
CENTRE SPEAKER
SUBWOOFER
2
2
4
4 4
Advertisement
Table of Contents
