Section Control Room - RME Audio Digiface Ravenna User Manual

18.4 Section Control Room

In the section Control Room the menu Assign is used
to define the Main Out which is used for listening in
the studio. For this output the functions Dim, Recall,
Mono and Talkback are automatically applied.
Additionally the channel will be shifted from the Hard-
ware Outputs into the Control Room section, and re-
named Main. The same happens when assigning
Main Out B or the Phones. The original name can be
displayed by the function Names in the View Options
- Show at any time.
Phones 1 to 4 will have Dim (set in Settings) and a
special routing applied when Talkback is activated.
Also putting them beside the Main Out increases the
overview within the output section greatly.
Dim. The volume will be reduced by the amount set
in the Settings dialog (F3).
Recall. Sets the gain value defined in the Settings dialog.
Speak. B. Switches playback from Main Out to Main Out B. The faders of the channels Main and
Speaker B can be ganged via Link.
Mono. Mixes left and right channel. Useful to check for mono compatibility and phase problems.
Talkback. A click on this button will dim all signals on the Phones outputs by an amount set up
in the Preferences dialog. At the same time the control room's microphone signal (source defined
in Preferences) is sent to the Phones. The microphone level is adjusted with the channel's input
fader.
External Input. Switches Main monitoring from the mix bus to the ste-
reo input defined in the Settings dialog (F3). The relative volume of the
stereo signal is adjusted there as well.
Assign. Allows to define the Main Out, Main Out B, and up to four
Phones outs. The listbox includes all 130 hardware output channels.
The output for the Cue signal, which is usually
Main, can also be set to one of the Phones out-
puts 1-4. This setting also controls the PFL mon-
itoring.
User's Guide Digiface Ravenna © RME
38