Page 1
Instruction Book Snow Thrower Model 627858x43A Manuel d’instructions chasse−neige modèle 627858x43A Read and keep this book for future reference. This book contains important information on SAFETY, ASSEMBLY, OPERATION, AND MAINTENANCE. Lisez et conservez ce manuel pour référence. Ce manuel contient des informations importantes concernant la SECURITE, LE MONTAGE, L’UTILISATION ET L’ENTRETIEN.
Page 2
NOTE: This unit is equipped with an internal combustion engine and must not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester Engine Exhaust, some of its constituents, and meeting applicable local or state laws (if any).
Page 10
ENGLISH CONTENTS noted in this Limited Warranty, we shall, at our Distributor for your area shown in the list option, repair or replace at no cost to the original provided with your unit or check the Yellow Page purchaser any part covered by this Limited listings in your local telephone directory.
Page 11
ENGLISH INTERNATIONAL PICTORIALS IMPORTANT: The following pictorials are lo- cated on your unit or on literature supplied with the product. Before you operate the unit, learn and understand the purpose for each pictorial. Safety Warning Symbols DANGER IMPORTANT Avoid Injury From DANGER DANGER Read Owner’s Manual...
Page 12
ENGLISH Safe Operation Practices for Snow Throwers As Recommended By: American National Standards Institute. IMPORTANT: Safety standards require operator 7. Never attempt to make any adjustments 11. Do not clear snow across the face of slopes. presence controls to minimize the risk of injury. while the engine (motor) is running (except Exercise extreme caution when changing Your snow thrower is equipped with such con-...
Page 13
ENGLISH ASSEMBLY NOTE: Make sure the cables are not 5. Tighten locknut (6) securely. caught between the upper and lower han- NOTE: Make sure all carriage bolts in flange dle. Read and follow the assembly and adjustment are tight. DO NOT OVERTIGHTEN. 5.
Page 14
ENGLISH Traction Drive Lever (1) - Select the forward or 3. To stop the engine, push the throttle control 5. Check the air pressure in the tires. The cor- reverse direction of travel. lever (13) to off and remove the ignition key rect air pressure is 14 PSI (1 BAR) to 17 PSI (8).
Page 15
ENGLISH 10. (Electric Start) Push on the electric start leave the choke control (14) in the off position 2. Move the throttle control (13) to the stop button (10) until the engine starts. Do not position. and do not push the primer button (9). If the crank for more than 10 seconds at a time.
Page 16
ENGLISH MAINTENANCE CHART CUSTOMER RESPONSIBILITIES SERVICE RECORDS Before First Every Every Every Fill in dates as you Each Before Each complete regular Season Storage Hours Hours Hours Hours SERVICE DATES service. √ √ √ Check Engine Oil Level √ √ Change Engine Oil √...
Page 17
ENGLISH CAUTION: Any greasing or oiling of the How To Check And Adjust The Cables 11. (Figure 15) To check the adjustment, de- press the drive lever and check the length above components can cause contamina- The traction drive cable and the auger drive tion of the friction wheel (3).
Page 18
ENGLISH 5. (Figure 19) Loosen the belt guide (9). Pull 12. Adjust the belt guide (9). See “How To Ad- 3. (Figure 23) Move the friction wheel (4) to the belt guide (9) away from the auger just The Belt Guide” in the Maintenance sec- the correct position.against the snap ring drive pulley (10).
Page 19
ENGLISH signed to break and protect the machine if an 5. Thoroughly clean the snow thrower. Replacement parts, except for the engine, transmission, transaxle or differential, are object becomes lodged in the auger housing. 6. Lubricate all lubrication points. See the Main- Do not use a harder bolt as the protection pro- available from the store where the product was tenance section.
Page 20
FRANÇAIS SOMMAIRE l’acheteur initial, toute pièce couverte par cette Pour localiser le centre de maintenance le plus garantie limitée jusqu’à l’expiration de la garantie proche, contactez le Distributeur de pièces INFORMATIONS SUR LE PRODUIT applicable. régional de votre région figurant sur la liste Les pièces d’usure normale comprennent les fournie avec votre machine, ou consultez les INFORMATIONS DESTINEES AU...
Page 21
FRANÇAIS PICTOGRAMMES INTERNATIONAUX IMPORTANT : les pictogrammes suivants sont situés sur votre appareil ou dans la do- cumentation ci-jointe. Avant de vous servir de la tondeuse, apprenez à reconnaître cha- que pictogramme. Symboles de signalisation de danger IMPORTANT DANGER DANGER DANGER DANGER Lire le manuel de l’utilisa-...
Page 22
FRANÇAIS REGLES DE SECURITE A SUIVRE POUR L’UTILISATION DES CHASSE-NEIGE SELON LES RECOMMANDATIONS DE L’AMERICAN NATIONAL STANDARDS INSTITUTE IMPORTANT : les normes de sécurité requiè- 7. Ne tentez jamais de faire de quelconques 12. N’utilisez jamais le chasse-neige sans les rent des contrôles de la présence du conducteur réglages lorsque le moteur est en marche protections nécessaires : déflecteurs, com-...
Page 23
FRANÇAIS MONTAGE 3. (Figure 2) Mettre le levier de vitesse (6) en Montage du déflecteur première vitesse de la marche avant. 1. (Figure 10) Retirer le boulon à tête ronde Lire et suivre les instructions de montage et de 4. (Figure 3) Soulever la poignée supérieure (1).
Page 24
FRANÇAIS Important ! Avant de démarrer la Les vis de cisaillement (19) - Afin de protéger la Déblaiement de la neige (Figure 2) machine, des vis de cisaillement sont conçues machine : 1. Embrayer le levier d’entraînement de la spécialement pour se briser si un objet se trouve fraise hélicoïdale (5).
Page 25
FRANÇAIS 11. (Démarrage manuel) Tirer rapidement sur la 1. Alors que le moteur est encore en marche, DANGER : Le starter est équipé corde du démarreur (12). Ne pas laisser la tirer d’un coup sec et continu deux ou trois d’une rallonge trifilaire conçue pour corde du démarreur (12) s’enrouler d’elle- fois la corde du démarreur (12).
Page 26
FRANÇAIS TABLEAU DE MAINTENANCE RESPONSABILITES DE L’ACHETEUR REGISTRE DES OPERATIONS D’ENTRETIEN Avant Complétez les dates au fur et à mesure 2 pre− Toutes Toutes Toutes Avant chaque des opérations d’entretien régulier effec- mières les 5 les 10 les 25 Chaque remis- DATES DES OPERATIONS utilisa-...
Page 27
FRANÇAIS Pièces à ne pas lubrifier (Figure 15) 1. Placer le chasse neige sur une surface pla- DANGER : vider l’essence à l’exté- rieur, à l’écart de toute source de 1. Ne pas graisser l’arbre hexagonal et le pi- flammes ou de feu. 2.
Page 28
FRANÇAIS 7. Vérifier le réglage du câble d’entraînement Si le chasse-neige n’avance pas, vérifier la 4. (Figure 22) Mesurer la distance entre le gui- courroie d’entraînement des roue pour détecter de la fraise. Voir “Vérification et réglage des de de courroie (2) et la courroie d’entraî- tout dommage ou toute usure.
Page 29
FRANÇAIS Le chasse-neige n’avance pas si le disque de 20. (Figure 27) Installer la roue droite (10) sur 9. Placer la machine dans un bâtiment bien l’axe (11) à l’aide des fixations retirées aupa- ventilé. friction est usé ou endommagé. Le disque de friction doit être remplacé...
Page 30
FRANÇAIS TABLEAU DE DEPANNAGE PANNE CAUSE REPARATION Démarrage difficile Bougie défective. Remplacer la bougie. Eau ou impuretés dans le système de Utiliser le drain de carburateur pour évacuer les distribution du carburant. impuretés et remplir avec de l’essence neuve. Le moteur tourne de manière irrégulière Conduit de carburant bouché, réservoir Nettoyer le conduit de carburant ;...
Page 31
Parts List Model 627858x43A − Liste de pièces Modèle 627858x43A − F-031031L...
Page 32
MODEL 627858x43A REPAIR PARTS ENGINE 25-2 25-1 Á Á Á Á Á Á 25-3 25-2 25-4 Ref. Drive Page Ref. Auger Housing Page Key No. Part No. Description Key No. Part No. Description - - - - - - ENGINE...
Page 33
MODEL 627858x43A REPAIR PARTS ELECTRIC START ASSEMBLY Part No. Description 6218 MOTOR, STARTER 6216 SCREW 6217 SCREW 6219 CORD, STARTER F-031031L...
Page 34
MODEL 627858x43A REPAIR PARTS FRAME Ref. Engine Page Ref. Auger Housing Page Ref. Drive Page F-031031L...
Page 35
MODEL 627858x43A REPAIR PARTS FRAME Key No. Part No. Description 1501055E701 COVER, BOTTOM 310169 SCREW, 1/4-20X .63 1501226 YZ IDLER ASSEMBLY, AUGER 711682 PIN, HAIR .38DIAX1.64LG 761761 PIN, CLEVIS 3/16” DIA 165x159 SPRING, TENSION 761675 YZ ASSY., SPRING ATTACH 585781 BOLT, 3/8-16X1.25 CARR.
Page 46
MODEL 627858x43A REPAIR PARTS CHUTE ROD Ref. Handle Assy 852-9 852-5 852-8 852-13 852-10 Ref. Auger Housing Assy 852-1 1 852-1 852-2 852-6 852-7 852-3 F-031031L...
Page 47
MODEL 627858x43A REPAIR PARTS CHUTE ROD Key No. Part No. Description 852-1 1501309 YZ ASSEMBLY, YOKE & ROD 852-2 313431 WASHER, CURVED SPRING 852-3 1501067 GEAR, CHUTE ROTATION 9T 852-5 579493 PIN, COTTER 852-6 1501306E701 BRACKET, GEAR MOUNT 852-7 1501293...
Page 48
MODEL 627858x43A REPAIR PARTS REMOTE CONTROL Ref. Control Panel Ref. Engine Mount Bolt Ref. Upper Chute Ref. Lower Chute Key No. Part No. Description Key No. Part No. Description 318468 TENSION SPRING 1001221 TRIM STRIP, BLACK 310088 BOLT, SHOULDER 071372...
Page 49
MODEL 627858x43A REPAIR PARTS GEAR CASE Key No. Part No. Description Key No. Part No. Description CASE, GEAR, RH 73905 KEY, WOODRUFF #91 CASE, GEAR, LH 53737 RING, QUAD 0.924 ID 910828 SCREW, 5/16-24 x 1.00 583126 BEARING, FLANGE 71100 NUT, 5/’16-24...
Page 50
MODEL 627858x43A REPAIR PARTS WHEELS Ref. Drive Page Key No. Part No. Description Key No. Part No. Description 1501563 YZ SHAFT, AXLE 580362 TIRE & RIM, LEFT 1501089 SPRKT & HUB 1501032E DISC, WHEEL 01x193 SCREW, 1/4-20X1.75 2001066 SCREW 15x145...
Page 51
MODEL 627858x43A REPAIR PARTS DRIFT CUTTER ASSEMBLY Key No. Part No. Description 762348E701 DRIFT CUTTER 340720 BOLT 12021 WASHER 711604 WINGNUT 11261 STOP, PLASTIC F-031031L...
Page 52
MURRAY, INC. LAWN MOWER CENTRAL PARTS DISTRIBUTORS DISTRIBUTEURS RÉGIONAUX DE PIÈCES MURRAY, INC. BILLIOU’S, INC. FRANK EDWARDS CO. GULF COAST ENGINE, INC. 1343 South Main St. 3626 Parkway Blvd. 4202 Russell Dr. Porterville, CA. 93257 West Valley, UT 84120 Corpus Christi, TX. 78408 (559) 784−4102 1−877−245−5468 1−800−318−0201...