Table of Contents
Advertisement
Operation Manual / TPL67-C.. - TPL71-C..
8 Disassembly and assembly / 8.7 Installing cartridge group
© Copyright 2020 . All rights reserved.
Fit O-ring (42012).
u
Attach lifting gear to the shackle of the lifting device (90190) and turn
u
the compressor casing (72000).
Screw three press-off nuts (61090) onto bearing casing studs, equally
u
distributed around circumference, and screw up to end of thread by
hand.
Push compressor casing (72000) fully onto cartridge group and se-
u
cure using nuts (61037).
Secure three press-off nuts (61090) against compressor casing
u
(72000) by tightening them to specified torque (see chapter Table of
tightening torques).
Remove lifting device (90190).
u
HZTL2488_EN
Rev.G
March 2020
Advertisement
Table of Contents
