Installing The Based Bracket To The Wall - Sharp AN-52AG2 Operation Manual

Installing the Based Bracket to the Wall

Based bracket assembly
1
Assemble based brackets A and B as shown in the illustration following the procedure given
below and secure the brackets with the 16 screws C (M6, 10mm).
Based bracket B
When installing in an LCD television with a bracket pitch of 400mm
Applicable models: LC-52RX1W, LC-46RX1W, LC-42RX1W
Use one of the following assembly configurations to assemble the based
bracket in accordance with the height of the LCD television to be installed. For
each configuration, follow the stamped instruction marks (See below) on based
brackets A and B to assemble the bracket.
Based bracket A
Based bracket B
Based bracket A
Based bracket B
E-4
Information Regarding Based Bracket Assembly
Assembly configuration (1)
Height: Standard (The height can be changed +5cm
163mm
Based bracket A: Stamped mark C
Based bracket B: Stamped mark A
Assembly configuration (2)
Height: +5cm (The height can be changed -5cm after
163mm
Based bracket A: Stamped mark C
Based bracket B: Stamped mark B
after the bracket is installed to the wall.)
the bracket is installed to the wall.)
Based bracket A