Jimmy JF41 Instruction Manual page 8

4. After removing the fan blade, rotate the cover
plate of the rear cover counterclockwise and
remove the cover after unscrewing. (Picture 11)
The installation
After the cleaning of all parts of the fan
components, they can be assembled in reverse
according to the disassembly sequence. Please
note the following points:
1. When the rear cover is assembled with the
motor & control part, the anti-stay groove of
the rear cover shall be aligned with the clamp
groove of the motor & control part, and the
cover plate of the rear cover shall be tightened.
(Picture 12)
2. When installing, please note that the groove
behind the fan blade shall be stuck on the limit
pin of the motor shaft. (Picture 13)
3. When installing the front cover, the arrows "
" " should be aligned. Rotate the front cover
clockwise until " " and "
the screw and finish the installation.
Cleaning and maintenance of all parts
Parts that can be cleaned with water: Rear cover, fan
blade, front cover (Picture 14).
Use neuter kitchen cleaner to dip wet soft cloth or
sponge and then clean the parts. After cleaning,
please put them in cool and dry place, avoiding direct
sunlight.
Parts not to be cleaned with water: fan blade knob,
motor & control assembly, support pole and base
assembly (Picture 15). Please use a soft dry cloth to
gently wipe them, do not use banana oil, volatile oil,
detergent, alkaline cleaning fluid.
Note: Do not put them into the water to clean, so as not to
burn the internal electrical parts and damage the machine.
Storage
If the machine is to be long idled, unplug the
power cord and store it in a dry place.
6
" and
" are aligned. Tighten
11
12
Clamp groove
Anti-stay groove
13
Groove
14
Rear Cover Fan blade
15
Fan blade
knob
Rear
housing
Rear Cover
Cover plate of
the rear cover
Limit pin
Front cover
Support ＆ base assembly