Table of Contents
Advertisement
Basic Operations
Adjusting the balance
1. Press the [ A-M ] button and select "BAL".
2. Turning the [ ROTARY ] knob clockwise empha-
sizes the sound from the right speaker; turn-
ing it counterclockwise emphasizes the sound
from the left speaker.
∗ The factory default setting is "0". ( Adjustment
range: L13 to R13 )
Adjusting the fader
1. Press the [ A-M ] button and select "FAD".
2. Turning the [ ROTARY ] knob clockwise empha-
sizes the sound from the front speakers; turn-
ing it counterclockwise emphasizes the sound
from the rear speakers.
∗ The factory default setting is "0". (Adjustment
range: F12 to R12)
Note:
• Bass and Treble can only be adjusted when the "Z-
enhancer" is off.
Turning on/off MAGNA BASS EX
The MAGNA BASS EX does not adjust the low
sound area like the normal sound adjustment func-
tion, but emphasizes the deep bass sound area
to provide you with a dynamic sound.
∗ The factory default setting is off.
Press and hold the [ A-M ] button for 1 second or
longer to turn the MAGNA BASS EX and "M-B EX"
in the display lights on or off.
Switching display
Press and hold the [ BND ] button, and then press
the [ DISP ] button to select the desired display.
The display switches in the following order:
Main Display
Clock Display
∗ If the display is changed by other button operation
when the clock is displayed, the clock display re-
turns automatically after the operation.
Illumination dimmer function
When the illumination line of this unit is connected
with the car-side illumination signal line, the dis-
play illumination of this unit dims in connection
with turning on the car-side illumination.
ADJ mode adjustment
1. Press [ D ] button more than 1 second at POWER
2. Press [ D ] button again at ADJ mode will cancel
3. Press [ SRC ] button will also release ADJ mode.
4. ADJ mode will also be released when current
5. Press [
6. The ADJ Mode Title will be display for 2 sec-
Adjusting clock setting
1. Press the [ D ] button and press [
2. Press [
3. Press [
4. Turn the [ ROTARY ] knob clockwise to in-
5. Press [
Note:
• If you remove the vehicle's battery for a check or
Adjusting screensaver setting
Main Display ...
1. Press the [ D ] button and press [
2. "SS ON" or "SS OFF" will be display after 2
3. Turn the [ ROTARY ] knob clockwise to turn on
4. If Screensaver setting is set to on, Screensaver
ON mode to enter ADJ mode, the previous se-
lected ADJ items will be called out.
ADJ mode and return to previous display.
source mode is changed. (Mode changes of
LOADING, EJECT, interruption and interrup-
tion release)
] / [
] button to switch the ADJ mode
items,
onds before showing the ADJ Mode setting.
to select "CLOCK (E)".
] button to start clock adjustment,
the HOUR is selected and blinking by default.
] / [
] button to toggle HOUR and
MINUTE selection.
creases hour/minute or counterclockwise to
decrease hour/minute.
] button to confirm the clock setting,
the clock will blink for 2 seconds and return to
"CLOCK(E)".
repair, the clock will be reset, so you must set it
again.
to select "SCRN SVR".
seconds.
the screensaver or counterclockwise to turn off
the screensaver.
will be activated after 30 seconds of no key op-
eration.
] / [
] button
] / [
] button
11
DB256
Advertisement
Table of Contents
