Related Manuals for Baby Control BC-2200
Summary of Contents for Baby Control BC-2200
- Page 1 BC-2200 BC-2210 BC-2230 Instructions for Use Instructions for Use for the Baby Control breathing monitor: • BC-2200 with one sensor pad • BC-2210 with two sensor pads • BC-2230 with three sensor pads...
- Page 2 Description of functions of the Baby Control breathing monitor 1. The Baby Control continuously monitors the breathing of a baby sleeping in his cot, crib or pram etc.
- Page 3 It is discreet and easy to use. 2. Uniquely large monitored area The size of one sensor pad is 300 x 500 mm. Depending on the model, the Baby Control breathing monitors have either one, two or three sensor pads. The device with three sensor pads is able to monitor the entire surface of most baby cots.
- Page 4 Thus it is not necessary to remove the sensor pads from under the baby’s cot, you only need to take with you the easily detachable control unit. The Baby Control BC- 2230 breathing monitor is an excellent choice for those parents who prefer to use several...
- Page 5 5. Attach the control unit to the baby’s cot using the Velcro straps. The Baby Control cable must be secured so that the baby cannot pull it. The best way to do this is to wind it around one of the cot bars.
- Page 6 ON/OFF button again within 5 seconds, the monitor stays on and returns to normal operation. IMPORTANT: The display of the Baby Control may show values 1 –9 even if there is no movement or the sensor pads are disconnected. This is not an error, the device is only adjusting to surrounding conditions.
- Page 7 If another value than 0 is flashing on the display and the baby is not in the cot, the Baby Control breathing monitor is detecting vibrations from some source in its surroundings. In such cases do not use it until the source of vibrations is found and removed.
- Page 8 This may be checked on the display when the device is switched on and the baby is not lying in the bed! In the absence of the baby, Baby Control breathing monitor must sound an alarm under normal conditions.
- Page 9 Low battery voltage of Baby Control breathing monitor After the Baby Control is switched on by the ON/OFF button (1) the letter “E” will constantly flash on the display accompanied by an acoustic signal. This means that the battery voltage is low.
- Page 10 Baby Control breathing monitor must not be used with rechargeable AA batteries because their combined rated voltage is only 2.4V! The battery condition is tested automatically every time the device is switched on. Testing the Baby Control breathing monitor To test the Baby Control baby monitor perform the following tests.
- Page 11 Sensing unit: BC-2101 sensor pad Recommended weight of baby from 2 kg Dimensions 500×305×15 mm Weight 750 g www.babycontrol.eu www.babycontrol.eu www.babycontrol.eu...
- Page 12 REANIMATION INSTRUCTIONS FOR PARENTS Picture 1.:The device alarms. Go to the baby, uncover him/her, turn him/her on the back and shout at him/her loudly. Pinch him/ her strongly on the shoulder. If the baby does not respond to these strong stimuli (moving, cry, whimper), he/she is likely to be unconscious.