Promis KG-200 Manual page 16

Check that the gas pipe that you want to use is in accordance
with the rules in force in your country and it has already
assembled with the pressure reducer with the characteristics
described in the chapter of Safety Instruction and in the
technical data table.
Insert into the gas pipe a full mesh metal clamp suitable for
LPG gas pipes.
To insert the gas pipe in the stove gas's connector on the back
of the stove and push it until the pipe is inserted up to the
connector for at least 2cm.
Tighten the metal clamp in order to seal safely the rubber hose
to the stove connector.
LPG CYLINDER ASSEMBLY:
Before assembling the cylinder, turn the burner valve's knobs
clockwise until them reach the closed position.
Place the gas cylinder in a stable and dry surface
Connect the pressure regulator already assembled to the
gas pipe to the LPG cylinder making sure you have correctly
inserted the seal gasket supplied with the cylinder.
Always use the new gaskets supplied together with the LPG
cylinder.
Tighten the regulator to the cylinder to prevent gas leakage.
Check that the gas hose is not twisting. In case, rotate the pipe
in order that every twist or curve is eliminated and the tube has
a linear shape.
Turn the cylinder's valve knob until fully open in order to allow
the gas LPG to feed the stove.
Keeping the stove taps closed for fice minutes and check does
not spread out smell of gas before proceeding with the use of
the stove.
To verify that the installation has been done successfully, pour
soapy on the joints of every connection. Any leaking will be well
visible using this solution.
Attention: Never use a flame to check the Gas leaking.
PRODUCT'S USE:
Lightly press and turn counterclockwise the burner valve's knob
according the burner you want use.
Put a lighter close to the defined burner
16