Operating SDoT Server V3B..............................................16 Replacing the Audit-Hard Disk – H1........................................16 Seite 2 von 27 iesy GmbH www.iesy.com | sales@iesy.com | Tel.: +49 (2354) 70655 0 Local court Iserlohn | HRA 9826 | USt-IdNr: DE339671635 | Managing Director: Dipl.-Ing. Martin Steger...
Page 3
Block diagram ........................................................24 Dimensions (mm) SDoT Server V3B .........................................26 Revision Tracking ......................................................27 Seite 3 von 27 iesy GmbH www.iesy.com | sales@iesy.com | Tel.: +49 (2354) 70655 0 Local court Iserlohn | HRA 9826 | USt-IdNr: DE339671635 | Managing Director: Dipl.-Ing. Martin Steger...
The system may only be installed by trained and qualified personnel. General risks by ignoring the safety Informations The SDoT server V3B is state-of-the-art and safe to operate. The system may present residual risks if it is used and operated improperly by untrained personnel. Any person responsible for installing, commissioning, maintaining, or repairing the system must have read and understood the operating instructions and, in particular, the safety notes.
When disposing of batteries, comply with local regulations and laws. Seite 5 von 27 iesy GmbH www.iesy.com | sales@iesy.com | Tel.: +49 (2354) 70655 0 Local court Iserlohn | HRA 9826 | USt-IdNr: DE339671635 | Managing Director: Dipl.-Ing. Martin Steger...
Note: The system may only be opened by trained specialists. Seite 8 von 27 iesy GmbH www.iesy.com | sales@iesy.com | Tel.: +49 (2354) 70655 0 Local court Iserlohn | HRA 9826 | USt-IdNr: DE339671635 | Managing Director: Dipl.-Ing. Martin Steger...
Assembly SDoT-Server V3B The SDoT Server V3B is a 19" unit for use in server racks. Suspension bolts on the rear and eyelets on the front are used for mounting in 19" racks. Alternatively, mounting rails can be used to allow the unit to be pulled out of an IT cabinet for operation.
Connect the two marked IEC plugs - redundant power supply unit Seite 10 von 27 iesy GmbH www.iesy.com | sales@iesy.com | Tel.: +49 (2354) 70655 0 Local court Iserlohn | HRA 9826 | USt-IdNr: DE339671635 | Managing Director: Dipl.-Ing. Martin Steger...
Page 11
User Manual V-180131-BHA00 If a power unit is defective, you can replace the power unit. switch off the SDoT Server V3B and remove it from the power supply pull the plug out of the defective power supply unit press the black locking lever in the direction of the bow handle...
User Manual V-180131-BHA00 Server Rear Side The rear of the SDoT Server V3B has a battery compartment and two power supply units, the slide-in bolts and the openings for the fan module. Insertion bolt in 19“-Rack Mass fan module Battery compartment...
The device is switched on via the P1 button. The integrated LED lights up green when the system is powered on. Seite 15 von 27 iesy GmbH www.iesy.com | sales@iesy.com | Tel.: +49 (2354) 70655 0 Local court Iserlohn | HRA 9826 | USt-IdNr: DE339671635 | Managing Director: Dipl.-Ing. Martin Steger...
For information on the status and changing of the audit hard disk, refer to the user manual of the SDoT Product. Follow the steps below to securely change the audit disk 1. log in to the SDoT Server V3B as an auditor 2. open Status Audit system 3. click on System » Change HDD the entry next to the third diode indicates a change 4.
User Manual V-180131-BHA00 Starting the SDoT Server V3B After installing the SDoT Server V3B in a 19" IT cabinet and connecting it to the power supply using the IEC cables, the device can be put into operation. The basic steps for operating the SDoT Server V3B are described below. For detailed information, refer to the manual for your SDoT product.
The following describes the meaning of the symbols used on the LC touch display. LC-Touchdisplay – T1 After the SDoT Server V3B has booted up successfully, the LC touch display shows the operating status and allows information to be queried.
Page 19
4. Use the arrow keys to the left of the menu items (4) to move the menus up and down Seite 19 von 27 iesy GmbH www.iesy.com | sales@iesy.com | Tel.: +49 (2354) 70655 0 Local court Iserlohn | HRA 9826 | USt-IdNr: DE339671635 | Managing Director: Dipl.-Ing. Martin Steger...
Shutdown and Restart You can use the LC touch display to both shut down and restart the SDoT Server V3B. click on the menu button with the three horizontal lines (7) at the bottom right to display the menus...
EU, for example, has its own legislation. Package The original packaging of the SDoT server V3B is made of recyclable material. For ecological reasons, you should refrain from returning the empty packaging to us. Package dimensions: 765 x 580 x 144 mm...